Coaxial cable Rangeful RG213U 30 m, all-copper conductor, 50 Ω, PVC jacket

Rangeful RG213U 30 m coaxial cable features an all-copper center conductor and a nominal impedance of 50 Ω. The cable is supplied on a 30 metre length and is fitted with a PVC outer jacket that provides mechanical protection and basic weather resistance for outdoor and indoor RF and antenna installations. It is engineered for signal transmission between transmitters, receivers and antennas where low attenuation and stable impedance are required.

Advantages

The all-copper conductor offers consistent electrical conductivity and improved signal transfer compared with copper-clad alternatives. The 50 Ω impedance matches common RF and radio equipment, minimizing reflections when connectors and equipment of the same impedance are used. The PVC jacket increases abrasion resistance and provides a degree of protection against sunlight and moisture for general outdoor use. The 30 m length simplifies installations where a moderate run between equipment and antenna is needed.

Suitable for

• Connecting radio transceivers to antennas in amateur and professional installations
• Short- to medium-length RF runs between transmitters and receivers
• Outdoor antenna feeders with basic weather exposure
• Temporary or permanent wiring in communication setups requiring 50 Ω impedance

Key specifications

• Cable type: RG213U coaxial cable
• Center conductor: solid all-copper
• Impedance: 50 Ω nominal
• Length: 30 m
• Outer jacket material: PVC (polyvinyl chloride)

How to use

Measure and cut the 30 m coaxial cable to the required length for your installation, allowing additional slack for routing. Strip the outer jacket, braid and dielectric according to connector manufacturer recommendations, taking care to maintain the integrity of the all-copper center conductor. Install compatible 50 Ω connectors and secure connections to transmitters, receivers or antennas. Route the cable to avoid sharp bends, pinch points and prolonged compression; secure it with appropriate clips or straps that do not crush the jacket.

Usage recommendations

For best performance, use connectors and equipment rated for 50 Ω systems and keep cable runs as short as practical to reduce loss. When used outdoors, protect exposed connectors from water ingress with suitable sealing boots or tape. Avoid prolonged exposure to direct sunlight where possible and inspect the PVC jacket periodically for signs of wear or cracking.