Coaxial cable Rangeful RG58/U N male to N female 50 Ω, 10 m

Coaxial cable Rangeful RG58/U N male to N female 50 Ω, 10 m is a 10-metre RF transmission cable built on the RG58/U standard. It features an N male connector on one end and an N female connector on the other, and is intended for 50 ohm systems. This cable is suitable for transferring radio frequency signals between antennas, test instruments and radio equipment where a flexible, industry-standard coaxial connection is required.

Advantages

The cable uses RG58/U construction which provides a reliable characteristic impedance of 50 Ω and consistent signal behavior across typical VHF and UHF ranges. N-type connectors at both ends deliver secure threaded connections with good mechanical stability and improved shielding compared with some smaller connector types. The 10 m length offers extended reach for installations and test setups while maintaining flexibility for routing and handling.

Suitable for

• Connecting antennas to transceivers and receivers in radio systems
• Laboratory and RF test equipment connections
• Temporary and permanent cabling in networking and communications setups requiring 50 Ω impedance
• Field measurements and portable radio installations

Key specifications

• Cable type: RG58/U coaxial
• Connector A: N male (threaded)
• Connector B: N female (threaded)
• Characteristic impedance: 50 Ω
• Length: 10 m
• Typical use: RF signal transmission, antenna feeds, test equipment
• Flexibility: moderate — suitable for routing and laboratory use

How to use

Inspect connectors and cable for any visible damage before installation. Ensure mating surfaces and threads on N connectors are clean and free from debris. Hand-tighten the N-type coupling nut and then use an appropriate torque wrench or spanner if specified by your equipment guidelines to achieve a secure connection without over-tightening. Route the cable with gentle bends respecting the cable's minimum bend radius to avoid deformation of the dielectric or conductor. For test setups, connect the cable between the transmitter/receiver or test instrument and the antenna or DUT, taking care to minimize sharp bends and to avoid placing the cable near strong sources of interference.

Usage recommendations

For best performance, avoid kinking the cable and secure it with non-compressive clamps. When used outdoors or in harsh environments, protect the connectors from moisture and corrosion by using appropriate weatherproofing boots or tape. Verify system SWR or return loss after installation to confirm correct impedance matching and to detect potential connector or cable issues.