Coaxial cable Rangeful RG58/U N male to N female 50 Ω 12 m

Rangeful RG58/U coaxial cable with N male to N female connectors is a 12 meter, 50 Ω cable designed for RF signal transmission. It follows standard RG58/U construction to balance flexibility and electrical performance, providing a straightforward connection between N-type devices. The cable is suitable for extending reach in amateur radio setups, test benches and antenna feed lines where a 50 ohm impedance match is required.

Advantages

This coaxial cable offers a consistent 50 Ω characteristic impedance and factory-fitted N-type male and female connectors for dependable mating with N-type equipment. The RG58/U construction gives a flexible jacket that is easy to route in confined spaces while preserving signal integrity for VHF and UHF frequencies commonly used in amateur radio and measurement tasks. The 12 m length reduces the need for additional adapters and minimizes connector losses by providing a single continuous run between devices.

Suitable for

• Amateur (ham) radio station interconnections and antenna feeds
• Laboratory and test equipment cabling for RF measurements
• Temporary or semi-permanent antenna installations
• Connecting transceivers, amplifiers, filters and antennas with N-type ports

Key specifications

• Nominal impedance: 50 ohm
• Cable type: RG58/U standard coaxial construction
• Connector type: N male to N female
• Length: 12 meters
• Typical use: RF signal transmission for VHF/UHF frequency ranges
• Flexibility: medium, suitable for routing and repositioning

How to use

Inspect connectors and cable for visible damage before use. Connect the N male end to the corresponding N female port on the transmitting or measurement device and attach the N female end to the receiving device or antenna feedpoint, ensuring threads are fully engaged and hand-tightened; use a torque wrench only if specified by the equipment manufacturer. Route the cable to avoid sharp bends, tight kinks and sources of excessive heat or mechanical stress. Keep cable runs as short and direct as practical to limit insertion loss; when coiling for storage, use a loose coil to prevent deformation.

Usage recommendations

For best RF performance, maintain proper connector mating and avoid repeated rough handling. Where permanent outdoor installation is required, supplement the cable with appropriate weatherproofing at connector joints and consider higher-specification low-loss cables if run lengths or frequency bands demand reduced attenuation.