Coaxial cable Rangeful N Male to N Male RG58/U 50 Ω, 5 m

Rangeful N Male to N Male RG58/U 50 Ω coaxial cable, 5 m, is designed for RF signal transmission where a compact, flexible cable with standard RG58/U characteristics is required. The cable features N male connectors on both ends and a nominal 50 ohm impedance appropriate for antennas, test instruments and networking equipment that accept N‑type terminations. At 5 meters length it provides a balance between reach and manageable loss for moderate‑frequency applications.

Advantages

This coaxial cable combines standard RG58/U construction with N male connectors to deliver consistent electrical performance, ease of installation and mechanical reliability. The 50 Ω impedance supports commonly used RF systems and measurement setups. Its flexible jacket and standardized connector interface simplify routing and repeated connections during testing or equipment swaps.

Suitable for

• Antenna connections for devices that use N male terminations
• Laboratory and test equipment interconnections
• Networking devices and RF modules requiring 50 Ω cabling
• Temporary or permanent installations with moderate-frequency signals

Key specifications

• Cable type: RG58/U
• Connector type: N male to N male
• Impedance: 50 Ω (nominal)
• Length: 5 m
• Intended use: RF signal transmission, antenna and test equipment connections
• Construction: coaxial with central conductor, dielectric, shield and outer jacket

How to use

Connect each N male connector to the corresponding N female socket on your antenna, transceiver, spectrum analyzer or network device. Hand‑tighten the connector coupling nuts until secure, then use a torque wrench suitable for N‑type connectors if specified by the equipment manufacturer to avoid over‑tightening. Route the cable to avoid sharp bends and prolonged compression; maintain the cable bend radius recommended for RG58‑type cables to minimize signal degradation.

Usage recommendations

For reliable RF performance, verify that connected equipment uses 50 Ω ports and that connectors are clean and undamaged. For outdoor or permanent installations, consider additional environmental protection for the cable and connectors to prevent moisture ingress and mechanical wear.