Coaxial cable Rangeful N male to N male RG58/U 50 Ω 7 m

Coaxial cable Rangeful N male to N male RG58/U 50 Ω 7 m is a flexible, shielded RF cable designed to connect devices with N-type male connectors. Constructed to RG58/U specifications with 50 ohm impedance, this 7-meter cable is intended for transmission of radio frequency signals between antennas, test instruments and RF equipment where a reliable 50 Ω coaxial link is required.

Advantages

The cable combines a standardized RG58/U core with N male connectors on both ends to ensure compatibility with a wide range of radio and measurement equipment. Its 50 Ω characteristic impedance supports proper matching for many RF systems, reducing reflections and preserving signal integrity. The shielding and connector construction provide mechanical robustness and consistent electrical performance over the cable length, while the flexible jacket facilitates routing in confined spaces.

Suitable for

• Antenna connections for radio transceivers and receivers
• Laboratory and bench testing with RF instruments
• Linking amplifiers, filters and other RF components
• Temporary or permanent installations requiring 50 Ω coax

Key specifications

• Cable type: RG58/U coaxial
• Connector type: N male to N male
• Impedance: 50 Ω
• Length: 7 m
• Shielding: braided shield (typical for RG58/U)
• Jacket: flexible PVC (typical construction for routing)

How to use

Connect each N male connector to the corresponding N female port on the devices to be linked, ensuring threads are engaged and hand-tightened; use a torque wrench to the manufacturer's recommended torque if available to avoid damage or poor contact. Route the cable to avoid sharp bends, pinch points and sources of strong electromagnetic interference. Verify continuity and correct impedance matching within the RF system before applying high power.

Usage recommendations

For optimal performance, avoid repeated flexing near the connectors, keep cable runs as short as practical for your application, and inspect connectors regularly for corrosion or mechanical wear. When used with high-frequency or high-power signals, confirm connector torque and check for heating during initial operation.