Coaxial Cable Rangeful RP‑SMA Male to N Male RG58/U 50Ω 1 m

Rangeful coaxial cable with RP‑SMA male to N male connectors, 1 meter long and built on RG58/U with 50 Ω characteristic impedance. This cable provides a flexible, short RF connection between devices that use RP‑SMA and N interfaces. Its construction is intended for general-purpose radio frequency signal transmission where a standard 50 Ω path is required, such as antenna extensions, radio equipment hookups and short test leads.

Advantages

The cable combines an RP‑SMA male connector on one end and an N male connector on the other, enabling direct connection between differently terminated RF devices without adapters. The RG58/U inner conductor and dielectric are matched to 50 Ω, delivering consistent impedance for minimized reflection in short runs. At one meter length the cable remains flexible and easy to route while offering sufficient reach for common installation and bench setups.

Suitable for

• Connecting antennas to routers, gateways or radios with RP‑SMA and N ports
• Laboratory and test setups requiring a short 50 Ω jumper
• Portable radio gear and field equipment interconnections
• Networking and wireless installations where a compact RF link is needed

Key specifications

• Cable type: RG58/U
• Characteristic impedance: 50 Ω
• Connector A: RP‑SMA male
• Connector B: N male
• Length: 1 m
• Typical use: RF signal transmission, short jumper

How to use

Ensure both devices are powered off or in a safe state for connection. Align the RP‑SMA male connector with the RP‑SMA female port and screw it on hand‑tight until secure, avoiding over‑torque. Align the N male connector with the corresponding N female socket and tighten according to the equipment’s connector tightening guidelines, typically hand‑tight plus a small turn with a torque wrench or spanner if recommended by the device manufacturer. Route the cable to avoid sharp bends and mechanical stress on the connectors.

Usage recommendations

Use this 50 Ω RG58/U jumper for short connections up to 1 m where signal loss is acceptable for the application. Avoid using the cable in environments with excessive moisture, abrasion, or where higher frequency, lower‑loss coax might be required; for long runs or critical high‑frequency links consider cables with lower attenuation and appropriate weatherproofing.