Coaxial cable Rangeful RP-TNC Male to RP-TNC Female RG58 50 Ohm 1 m

Rangeful RP-TNC Male to RP-TNC Female RG58 50 Ohm 1 m is a 1-metre coaxial cable assembled with RP-TNC male and RP-TNC female terminations on a flexible RG58 core. The cable is impedance-matched to 50 Ω for RF signal transmission and is intended for short-distance interconnections between antennas, routers, radio equipment and laboratory test setups that require reverse-polarity TNC connectors. The compact construction and standard RG58 dielectric make it suitable for common wireless and RF accessory connections where a reliable, low-loss link is needed over about one metre.

Advantages

This RG58 cable provides a consistent 50 Ω characteristic impedance to reduce reflections and maintain signal integrity across the link. The RP-TNC male to RP-TNC female terminations offer a secure threaded connection with reverse-polarity pin configuration compatible with devices that specify RP-TNC interfaces. The cable's 1 m length balances flexibility and reach for short interconnections while remaining easy to route in confined installations. Construction using standard RG58 materials yields a flexible cable suitable for repeated handling and positioning without excessive stiffness.

Suitable for

• Connecting Wi‑Fi routers, access points and antennas with RP‑TNC interfaces
• Linking radio transceivers, handheld radios and base stations that use RP‑TNC terminations
• Bench testing and RF measurement setups requiring 50 Ω cabling and RP‑TNC connectors
• Short patch connections between modules and adapters in wireless installations

Key specifications

• Cable type: RG58 coaxial
• Characteristic impedance: 50 Ω
• Length: 1 metre
• Connector A: RP‑TNC male (reverse polarity TNC male)
• Connector B: RP‑TNC female (reverse polarity TNC female)
• Construction: flexible dielectric and braided shield typical of RG58

How to use

Align the RP‑TNC connectors and screw them together by turning the connector coupling nut clockwise until hand‑tight; avoid over‑torquing. Route the cable to minimize sharp bends and avoid kinking the RG58 core, keeping bend radius gentle to preserve electrical performance. Use the cable for short RF interconnects between devices that require RP‑TNC terminations and a 50 Ω interface, verifying connector compatibility before connecting.

Usage recommendations

For best performance, keep the cable length as short as practical within the installation, avoid tight bends and heavy clamping, and ensure threaded RP‑TNC connections are hand‑tight and free of dirt or corrosion. If used in measurement setups, verify the system remains impedance‑matched and replace the cable if shield damage or connector wear is observed.