Coaxial cable Rangeful RP‑TNC Male to RP‑TNC Female RG58 50 Ω 2 m

Rangeful RP‑TNC Male to RP‑TNC Female RG58 50 Ω 2 m is a ready‑to‑use coaxial jumper cable designed for RF signal connections where reverse polarity TNC terminations are required. The cable uses RG58 coaxial construction with a specified 50 ohm characteristic impedance and a fixed 2‑meter length, providing a simple solution for connecting antennas, routers, test equipment and other RF devices that accept RP‑TNC interfaces.

Advantages

The RG58 core and 50 Ω characteristic impedance ensure consistent RF performance across common VHF and UHF frequency ranges. Reverse polarity TNC connectors on both ends allow compatibility with equipment that uses RP‑TNC interfaces without modifying existing connectors. The 2 m fixed length reduces signal loss from unnecessarily long runs while offering enough reach for typical installation or bench setups. The cable is factory‑terminated and tested for continuity, providing an immediately usable jumper for repairs and temporary or permanent connections.

Suitable for

• Connecting wireless routers, access points and external antennas with RP‑TNC ports
• Bench testing and measurement setups with RP‑TNC test ports
• Temporary RF link installations and on‑site troubleshooting
• Replacing damaged jumpers in existing RF systems using RP‑TNC

Key specifications

• Cable type: RG58 coaxial
• Characteristic impedance: 50 ohm
• Connector A: RP‑TNC male
• Connector B: RP‑TNC female
• Length: 2 meters
• Typical use: RF signal jumper for VHF/UHF frequency ranges

How to use

Inspect both RP‑TNC connectors and device ports for debris or damage before connecting. Align the RP‑TNC male and female connectors and hand‑tighten the coupling nut until secure; avoid excessive force to prevent thread or dielectric damage. Route the cable to minimize sharp bends and avoid kinking; secure with cable ties or clips if a fixed installation is required. For measurement or diagnostic use, connect one end to the test instrument and the other to the device under test, ensuring proper grounding and adherence to the instrument manufacturer’s safety procedures.

Usage recommendations

For best RF performance, keep the cable run as short as practical, avoid sharp bends with radii smaller than 5 times the cable diameter, and protect connectors from moisture and mechanical strain. When used in critical measurement setups, verify connector integrity and continuity with appropriate test equipment before relying on readings.