Coaxial cable Rangeful SMA male to SMA male RG58/U 50 Ω 10 m

Rangeful RG58/U coaxial cable with SMA male to SMA male connectors is a 10 meter, 50 Ω RF cable designed for reliable signal transmission between devices using SMA interfaces. The cable combines standard RG58/U construction with SMA male terminations on both ends, offering a balance of flexibility and shielding suitable for antenna connections, test setups and radio equipment where a 50 ohm match is required.

Advantages

The cable provides a consistent 50 Ω impedance throughout its length, reducing reflections and preserving signal integrity for RF applications. SMA male connectors at each end ensure secure mechanical connection and straightforward mating with equipment that uses SMA female ports. Flexible RG58/U construction makes routing and installation easier in confined spaces while maintaining adequate shielding against external interference.

Suitable for

• Antenna connections for radios and routers with SMA interfaces
• Laboratory and test equipment where a 50 Ω coaxial connection is needed
• RF prototyping and development rigs
• Connections between transceivers, signal generators and spectrum analyzers

Key specifications

• Type: RG58/U coaxial cable
• Connector configuration: SMA male to SMA male
• Impedance: 50 ohm
• Length: 10 m
• Cable characteristic: flexible construction with shielding suitable for general RF use
• Typical application frequency range: low to mid RF bands (dependent on system requirements)

How to use

Before connecting, verify that both devices accept SMA male-fitted cables or use appropriate adapters if needed. Align the SMA mating surfaces and screw the connectors by hand until finger-tight; avoid excessive torque to prevent damage to the connector threads or center pin. Route the cable to minimize sharp bends and avoid crushing; maintain bend radii consistent with RG58/U flexible cable to preserve electrical performance. For test bench setups, keep the cable length and routing consistent when comparing measurements to reduce variability.

Usage recommendations

Store the cable coiled loosely to prevent kinks and protect connector ends with caps when not in use. Inspect connector contacts periodically for dirt or corrosion and clean with appropriate electronic-contact cleaning materials if necessary. For applications requiring minimized insertion loss at higher frequencies, consider using shorter runs or alternative lower-loss cables if system requirements demand it.