Coaxial cable Rangeful TNC Male to TNC Male RG58/U 50 Ω 10 m

Rangeful coaxial cable TNC Male to TNC Male RG58/U 50 Ω 10 m is a flexible RF connection cable designed for reliable transmission of radio frequency signals. The assembly uses RG58/U type coaxial construction with a characteristic impedance of 50 ohms and threaded TNC male connectors on both ends. The 10 m length allows placement of antennas and radio equipment at a distance while maintaining consistent impedance for minimal signal reflections.

Advantages

This coaxial cable combines the well-known RG58/U construction with TNC male threaded coupling to provide a secure mechanical and electrical connection. The 50 Ω impedance supports standard RF equipment matching, while the flexible outer jacket simplifies routing through equipment racks and conduits. Threaded TNC connectors reduce the risk of accidental disconnection compared with non-threaded types and are suitable for environments where a compact, reliable RF link is required.

Suitable for

• Connecting antennas to radios and transceivers
• Laboratory and test bench RF measurement setups
• Amateur radio station wiring and portable field stations
• Linking RF modules, receivers, and signal generators

Key specifications

• Coaxial type: RG58/U construction
• Impedance: 50 Ω characteristic impedance
• Connector type: TNC male — both ends, threaded coupling
• Length: 10 meters
• Outer jacket: flexible insulating material suitable for indoor routing
• Typical frequency range: suitable for VHF, UHF and many RF applications (check system requirements)

How to use

Connect each TNC male connector to the corresponding TNC female socket on your antenna, transceiver, or test instrument by aligning the center pin and gently screwing the threaded coupling until hand-tight. Avoid over-tightening; secure connections prevent intermittent contact and reduce VSWR issues. Route the cable to minimize sharp bends and avoid tight coils. When deploying in a test setup, ensure connectors and cable are clean and free of debris to maintain consistent signal performance.

Usage recommendations

For best RF performance, use this 50 Ω RG58/U TNC cable in systems matched to 50 Ω impedance. Keep cable runs as short as practical for your setup to reduce loss at higher frequencies. Inspect connectors periodically for corrosion or wear and replace the cable if the outer jacket or shielding is damaged. For outdoor or permanent installations consider additional environmental protection or a cable type rated for direct burial or UV exposure.