Patchcord singlemode RBLINE PC-2LC/2LC-0.5 0.5 m, LC to LC single-mode fiber

RBLINE PC-2LC/2LC-0.5 singlemode patchcord, 0.5 m, with LC to LC connectors is a compact fiber jumper for short point-to-point connections in single‑mode optical networks. It is intended for linking equipment, patch panels and transceivers inside racks and enclosures where a short, reliable single‑mode connection is needed. The 0.5 m length limits excess fiber and improves cable management in dense installations.

Advantages

This LC to LC singlemode fiber patchcord offers low insertion loss and consistent optical performance suitable for telecom and data centre environments. Its small form factor and short length reduce clutter and minimize signal attenuation from unnecessary cable slack. The connectors provide stable mating with standard LC ports and maintain single‑mode alignment for reliable transmission.

Suitable for

• Interconnecting transceivers and network equipment in racks and patch panels
• Short links in data centres and telecommunication rooms
• Fiber optic test setups and laboratory measurements
• Upgrades or repairs where a compact single‑mode jumper is required

Key specifications

• Fiber type: single‑mode
• Connector type: LC to LC
• Length: 0.5 m
• Application: indoor rack/patch panel and equipment interconnects
• Typical features: low insertion loss, compact form factor

How to use

Route the patchcord between the two LC ports to be connected, avoiding tight bends and sharp kinks that may exceed the fiber bend radius. Insert each LC connector until it clicks to ensure secure mating. If used in a patch panel, manage the excess with cable organizers or routing guides to prevent strain on the connectors. Before installation, inspect connector endfaces for contamination and clean with appropriate fiber cleaning tools if necessary.

Usage recommendations

Store and handle the patchcord in a dust‑free environment and use dust caps when connectors are not in use. For optimal performance, follow standard single‑mode fiber handling procedures: avoid bending below the specified radius, clean connectors prior to mating, and secure cables to prevent strain. Choose the 0.5 m length when a short, neat connection is required within equipment racks or patch panels.