Network Media Converter ROLINE 10/100/1000T - 100/1000F

The ROLINE 10/100/1000T - 100/1000F network media converter converts between copper Ethernet (RJ45) and fiber optic connections, supporting data rates of 10/100/1000 Mbps on the copper side and 100/1000 Mbps on the fiber side. Its compact metal housing and standardized ports provide a straightforward solution for integrating fiber segments into existing copper networks, extending link distances and isolating network segments where required. The device is suitable for use in wiring closets, server rooms, and edge locations where a mix of copper and fiber cabling is present.

Advantages

This media converter provides reliable protocol-transparent conversion between twisted-pair and fiber links without altering data frames. The compact form factor allows flexible placement in confined spaces or on mounting panels. Support for gigabit speeds on both copper and fiber interfaces enables high-throughput links and backward compatibility with Fast Ethernet speeds. The converter reduces the need for rewiring by allowing incremental migration to fiber while maintaining existing copper equipment.

Suitable for

• Extending network links over long distances using fiber
• Connecting switches, routers or IP devices that require fiber uplinks
• Separating network segments to improve electrical isolation and reduce interference
• Integrating legacy copper equipment into fiber backbone networks

Key specifications

• Supported copper speeds: 10/100/1000 Mbps
• Supported fiber speeds: 100/1000 Mbps
• Fiber port types: compatible with 100/1000 Mbps fiber modules (SFP or fixed fiber dependent on model)
• Duplex mode: full and half duplex support where applicable
• Auto-negotiation: supported on copper interface
• Connector types: RJ45 on copper side; fiber connector on fiber side
• Housing: compact metal enclosure for durability and heat dissipation
• Mounting: desktop or rack/patch panel mountable depending on installation accessories

How to use

Install the converter near the devices to be connected or at an intermediate patch location. Connect the copper Ethernet cable to the RJ45 port and the appropriate fiber cable or SFP module to the fiber port. Power the unit using the supplied power adapter or PoE if the model supports it. Allow the converter to initialize; status LEDs indicate link and activity on each interface. Verify link speed and connectivity from connected devices and perform any required configuration on network equipment such as switches or routers to ensure proper operation.

Usage recommendations

Place the converter in a ventilated area away from direct heat sources. Use compatible fiber transceivers and matching fiber cable types (single-mode or multi-mode) to maintain link performance. Ensure proper cable strain relief and grounding practices where electrical isolation or surge protection is necessary.