Patch Cable S-Conn Cat.6A S/FTP double-shielded halogen-free black 5.0 m

S-Conn Cat.6A S/FTP double-shielded patch cable, 5.0 m in black, is designed for high-performance Ethernet connections up to 10 Gigabit. The cable uses S/FTP construction — an overall braided shield plus individual foil shields for each pair — to reduce electromagnetic interference and crosstalk in environments with multiple network lines or electrical noise. The halogen-free jacket minimizes toxic gas emission in the event of fire and supports installations where low-smoke, zero-halogen materials are required.

Advantages

The S/FTP design provides enhanced protection against external electromagnetic interference while maintaining pair-to-pair isolation for stable high-frequency signal transmission. A 5.0 m length offers flexibility for patching between switches, patch panels and workstations without excess cable slack. The halogen-free outer sheath improves safety characteristics in confined or public environments and the Cat.6A specification supports 10GBASE-T performance and higher bandwidth requirements.

Suitable for

• Patching between switches, patch panels and network outlets in data cabinets and racks
• 10 Gigabit Ethernet LAN installations requiring Cat.6A cabling performance
• Environments where low electromagnetic interference and reduced emissions are important (offices, server rooms, commercial spaces)
• Residential networks where robust, future-proof connections are desired

When it may not be suitable

This 5.0 m patch cable is not intended for in-wall permanent installation where plenum or specific building-code rated cable types are required; it is designed as a patch/patch-panel cable for exposed cabling runs. For very long horizontal runs or backbone cabling, structured cabling with appropriate installers and cable types should be considered instead.

Key specifications

• Category: Cat.6A, suitable for 10 Gigabit Ethernet
• Shielding: S/FTP — overall braid plus individually foiled pairs
• Length: 5.0 m
• Jacket: Halogen-free outer sheath
• Colour: Black
• Typical use: Patch cable for patch panels, switches and workstations

How to use

Connect one RJ45 plug into your network switch or patch panel and the other end to the device or wall outlet that requires network access. Avoid tight bends and excessive pulling force during installation; maintain bend radii recommended for Cat.6A cables to preserve performance. When routing near power cables, keep separation to reduce potential interference despite the cable's shielding. For rack and cabinet installations, secure the cable with appropriate cable management accessories to prevent strain on the connectors.

What to consider before purchase

• Verify required length — 5.0 m is intended for short patch connections, not long horizontal runs
• Confirm compatibility with your network equipment that supports RJ45 Cat.6A connections and 10GBASE-T if needed
• Check building code requirements for in-wall or plenum-rated cabling if you plan concealed installation
• Consider the need for additional shielding or grounding practices in environments with heavy EMI

Usage recommendations

For best results, use this S-Conn Cat.6A S/FTP patch cable for connecting active equipment inside racks and patch panels where 10 Gigabit performance and low emission materials are required. Route the cable with gentle curves, avoid sharp bends near the connectors, and secure with cable ties or management panels to maintain reliable high-frequency transmission.