Front Panel SCHROFF 19" with handle cutouts, 2 HU, 4 mm thick, Aluminum anodized

The SCHROFF 19" front panel with handle cutouts is a 2 HU panel manufactured from 4 mm thick anodized aluminum for use in 19-inch equipment racks and enclosures. It provides a lightweight yet rigid closure for electronics cabinets, server racks and industrial housings. The anodized finish increases corrosion resistance and provides an even surface suitable for repeated handling and installation in telecom, laboratory and industrial installations.

Advantages

The aluminum construction combines low weight with mechanical stiffness to support mounted components without excessive flex. Anodizing adds a protective oxide layer that improves resistance to corrosion and wear while maintaining a clean, consistent appearance. Pre-cut handle openings allow straightforward installation of common rack handles and facilitate front access to mounted equipment. The 2 HU height aligns with standard 19" rack unit dimensions for predictable placement within rack systems.

Suitable for

• Closing off unused 19" rack bays in telecom and server cabinets
• Front panels for industrial control and instrumentation enclosures
• Laboratory equipment racks where lightweight, rigid panels are required
• Applications that require handle installation for equipment extraction or maintenance

Key specifications

• Form factor: 19" front panel, 2 HU height
• Material: Aluminum, 4 mm thickness
• Surface treatment: Anodized finish for corrosion resistance
• Features: Cutouts for handle mounting
• Function: Rack closure panel providing structural support and front access

How to use

Install the panel into a standard 19" rack opening aligned to a 2 HU slot using appropriate rack screws or captive nuts. Position the handle cutouts to correspond with the handles to be fitted, and secure handles according to their manufacturer instructions. The panel may be used as a blanking or access panel; if used to support mounted hardware, ensure attachment points and fasteners are rated for the expected load and that ventilation and cable access requirements are maintained.

Usage recommendations

For long service life, clean the anodized surface with a mild detergent and a soft cloth; avoid abrasive cleaners and steel wool. When fitting handles, verify alignment and use corrosion-resistant fasteners to preserve the anodized finish and prevent galvanic reaction. Confirm rack unit alignment before final fastening to ensure correct fit within adjacent panels and equipment.