Secomp Cat6 (Class E) UTP Patch Cable, Blue, 2 m, Model S1752

Secomp Cat6 (Class E) UTP Patch Cable, Blue, 2 m (Model S1752) is a 2‑metre unshielded twisted pair network cable designed to meet Cat6 performance for Ethernet and wired LAN connections. The cable is intended for use between switches, routers, patch panels and workstation ports, supporting standard gigabit Ethernet links in office and data center environments. Its blue jacket makes circuit identification and patch panel management easier during installation and maintenance.

Advantages

The Secomp Cat6 UTP patch cable delivers consistent signal transmission for typical Cat6 applications and is compatible with existing RJ45 network ports. Its 2 m length is convenient for short links in racks, under desks and between closely located network devices without excess cable slack. The unshielded design simplifies installation in standard office and structured cabling systems while the color-coded jacket supports straightforward visual organisation.

Suitable for

• Connecting switches, routers and patch panels in horizontal cabling
• Workstation to wall port or patch panel connections in offices
• Data center patching for short copper links within racks
• Gigabit Ethernet and other Cat6-compatible LAN deployments

When it may not be suitable

This unshielded patch cable is not intended for environments with high electromagnetic interference where shielded cable (STP/FTP) would be required to reduce noise. It is a short 2 m length meant for local connections; for long-distance runs within buildings or between floors, permanent horizontal cabling or longer cables should be used. The cable meets Cat6 performance expectations but should not be assumed to provide higher category guarantees without certification in a specific installation.

Key specifications

• Cable category: Cat6 (Class E)
• Cable type: Unshielded Twisted Pair (UTP)
• Length: 2 m
• Connector: RJ45 terminated on both ends
• Color: Blue
• Intended use: Ethernet / LAN patching for gigabit networks

How to use

Plug each RJ45 connector into the corresponding network ports on your switch, patch panel, router or workstation. Route the cable to avoid tight bends and sharp edges; maintain minimum bend radius recommended for copper Ethernet cabling to preserve performance. For rack or patch-panel installations, use cable management and labeling to keep identification clear. Test the link with appropriate network testers if validation of Cat6 performance is required after installation.

What to consider before purchase

• Confirm required cable length; this product is 2 m for short links
• Decide whether unshielded (UTP) is sufficient or shielded cable is needed for noisy environments
• Ensure Cat6 performance meets your network speed and future upgrade plans
• Check color-coding preferences for patch panel and rack organisation

Usage recommendations

For reliable performance, avoid running the cable parallel to power lines and secure it with appropriate cable management. If multiple links require higher immunity to interference, consider shielded alternatives or rerouting. Use a cable tester to verify continuity and performance after installation.