Patch Cable UTP Cat6 (Class E) Secomp S1772, unshielded, white, 2 m

Secomp S1772 is an unshielded UTP patch cable built to Cat6 (Class E) standards, measuring 2 m with a white outer jacket. It is intended for Ethernet and structured cabling environments and connects devices such as switches, routers, patch panels and networked computers. The cable supports the signal quality and pair geometry required for reliable Gigabit Ethernet and typical LAN applications in home and office installations.

Advantages

The Secomp S1772 offers a balance of compliance and practicality: Category 6 performance characteristics in an unshielded UTP design, a 2 m length suitable for short to medium runs, and a neutral white jacket that integrates with most installations. Its connectors and cable construction are manufactured to maintain consistent pair alignment and reduced crosstalk within the limits of Cat6/Class E specifications, enabling stable data throughput for common network setups.

Suitable for

• Gigabit Ethernet connections between switches, routers and endpoints
• Patch panels and horizontal cabling in offices and home networks
• Workstation or equipment connections where a 2 m length is appropriate
• Structured cabling installations requiring Cat6 (Class E) rated patch leads

When it may not be suitable

This unshielded UTP Cat6 cable may not be suitable in environments with high electromagnetic interference (EMI) or where shielded cabling is explicitly required by site standards. It is also not intended for runs exceeding typical patch lengths; for long-distance backbone cabling or outdoor use, a different cable type with appropriate rating and environmental protection should be chosen.

Key specifications

• Category: Cat6 (Class E) performance
• Cable type: UTP (unshielded twisted pair)
• Length: 2 m
• Colour: white
• Connector type: RJ45 terminated on both ends
• Typical use: Ethernet / LAN / patching

How to use

Connect one RJ45-terminated end to the network device (switch, router or patch panel) and the other end to the target device such as a PC, access point or network printer. Ensure connectors are fully inserted until they click to secure the connection. Route the cable without sharp bends and avoid running it parallel to power cables to minimise interference. For best results, test the link after installation using network diagnostics or cable testers to confirm continuity and performance.

What to consider before purchase

• Verify that Cat6 (Class E) unshielded cables meet your site's EMI and grounding requirements
• Confirm that a 2 m length suits your planned device placement and cable routing
• Ensure RJ45 termination is compatible with your equipment and patch panels

Usage recommendations

Use the Secomp S1772 for short to medium patching within racks, desks and network furniture where Cat6 performance is needed without shielding. Keep cable runs neat, avoid tight bends, and pair with appropriate patch panels and connectors to preserve signal quality.