Ethernet patch cable ShiverPeaks S-Impuls 70002-6 6 m TAE-F to RJ-45, black, male–male

The ShiverPeaks S-Impuls 70002-6 is a 6 m black patch cable with a TAE‑F connector on one end and an RJ‑45 plug on the other, supplied male–to–male for direct wired connections. It is designed for linking telecommunication endpoints that use TAE‑F sockets to RJ‑45 network interfaces, enabling voice or low-speed data transmission in home and small office environments. The cable length and connectors provide a simple solution where an RJ‑45 network or adapter must interface with devices or wall outlets using TAE‑F.

Advantages

The cable combines two common connector types—TAE‑F and RJ‑45—into a single, factory‑terminated lead, reducing the need for adapters or additional wiring. Its 6 m length allows flexible placement of devices while keeping a neat installation; the black jacket offers discreet integration into existing setups. The male–to–male termination supports direct plug‑in connections for quick setup and minimal configuration.

Suitable for (tasks / use cases)

• Connecting telephones or terminal devices with TAE‑F sockets to RJ‑45 network interfaces
• Establishing a wired voice link between wall outlets and network equipment
• Temporary or permanent cabling in home networks and small office environments
• Integrating legacy telecommunication devices into modern structured cabling

Key specifications

• Cable length: 6 metres
• Colour: black outer jacket
• Connector A: TAE‑F (female socket end fitted as male plug interface)
• Connector B: RJ‑45 plug (8P8C), male
• Termination: factory‑assembled male–to–male patch cable
• Intended signals: voice and low‑speed data

How to use

Insert the TAE‑F end into the device or wall outlet equipped for TAE‑F connections and plug the RJ‑45 end into the corresponding network socket or adapter. Ensure connectors are fully seated to establish a stable contact. No additional tools or configuration are required for basic voice or simple data links; route the cable away from sources of electrical interference and secure it to avoid strain on connector ends.

Usage recommendations

For reliable performance, avoid sharp bends and excessive pulling on the cable. Use the 6 m length to position equipment for optimal signal routing and keep the cable clear of power lines and high‑interference equipment. For higher data rates or structured network requirements consider using purpose‑built Ethernet cables compliant with specific category standards.