Network patch cord Slim Wirewine SLIM-LS-K6A 0.5 m Cat6A U/FTP RJ-45 white 90-pack

SLIM Patchcords CAT6A 10 Gigabit LightPatch Cord, 0.50m, U/FTP, Ø 3.8mm, white is a slim, shielded Cat6A patch cable designed for high-density network environments and 10 Gigabit Ethernet. The round, four-pair, U/FTP construction and thin 3.8 mm outer diameter make this 0.5 m cable easy to route in crowded racks, patch panels and on desks, while the LSOH (low smoke, zero halogen) sheath offers flame-retardant protection. The connector uses a reinforced RJ45 plug with a break-resistant latch and an innovative short boot for easy handling.

Advantages

The cable supports 10/1/0.1 Gbit/s data rates and is tested both as a patchcord and in channel, providing reliable performance for modern networks. Its extremely flexible and thin design simplifies cable management in confined spaces and reduces clutter. The LSOH outer sheath increases safety in installations, and the special RJ45 material resists latch breakage even after repeated bending. The construction also supports Power over Ethernet standards (IEEE 802.3af and 802.3at).

Suitable for

• High-density switch stacks and crowded server or network cabinets
• Short-switch-to-switch or switch-to-patch-panel connections without additional management
• Connecting desk devices such as VoIP phones, printers, PCs and notebooks
• Industrial or space-constrained network points where a slim, shielded cable is required
• Field technicians carrying patch cords in a laptop bag
• Discrete home installations (under carpets, along skirting or through window seals)

Когда может быть не подходящим

The 0.5 m length and thin construction make this cable unsuitable for long runs or where higher mechanical protection is required. It is not intended as a permanent in-wall cabling solution where full conduit protection and specific in-wall ratings are required by local codes.

Key specifications

• Category: Cat6A (channel measured)
• Data transfer rate: up to 10,000 Mbit/s (10 Gbit/s)
• Shielding: U/FTP (foil-shielded pairs with overall drain)
• Cable diameter: 3.8 mm (approximately)
• Conductor: 4 twisted pairs, AWG32, 100% copper
• Sheath material: LSOH (low smoke, zero halogen), flame-retardant
• Connector type: RJ-45 straight male to RJ-45 straight male
• Special connector feature: reinforced, break-resistant latch with short boot design
• Length: 0.5 m
• Supports Power over Ethernet: IEEE 802.3af and IEEE 802.3at
• Colour: White

How to use

Connect one RJ45 end to a switch or patch panel port and the other end to the target device (switch, patch panel, VoIP phone, PC or notebook). Route the cable through the available space, taking advantage of its thin, flexible body to pass through narrow channels or under furniture. Press the RJ45 plug into the socket until the latch clicks; the reinforced latch is designed to withstand repeated use. For Power over Ethernet devices, ensure the connected equipment supports IEEE 802.3af/at.

What to consider before purchase

• Required cable length — this product is 0.5 m and is intended for short patching distances
• Intended installation environment — use conduit or in-wall rated cable where local regulations require it
• Need for shielding — U/FTP provides pair-level shielding suitable for noisy environments
• PoE requirements — compatible with IEEE 802.3af and 802.3at standards

Usage recommendations

Use these SLIM Cat6A 0.5 m U/FTP patch cords for short, high-density connections in racks, switch stacks and desk-level device links; avoid using them for long permanent runs or where additional mechanical protection is necessary.