Network Cable SOLARIX C6-315RD-2MB RJ45 CAT6 2m Red

The SOLARIX patch cable CAT6 SFTP PVC 2m in red is a shielded network cable built to meet CAT6 transmission requirements. It has a PVC outer jacket for mechanical protection and flexibility, AWG 26 stranded conductors, and RJ45 connectors with 50 μin gold-plated contacts. The cable uses S/FTP (individually foil‑shielded pairs plus overall braid) to reduce electromagnetic interference and is available with a slim, molded snag‑proof boot suitable for high‑density patch panels and active equipment.

Advantages

This CAT6 SFTP cable provides double shielding for improved noise immunity and stable signal transmission. The molded slim boot reduces crosstalk at the connector while allowing use in devices with dense RJ45 port layouts. Gold‑plated contacts and AWG 26 conductors ensure reliable connection quality and durability for typical networking applications.

Suitable for

• Gigabit Ethernet connections (1000Base‑T / 1000Base‑TX)
• High‑density patch panels and switches with RJ45 ports
• LAN installations for gaming, streaming, and office networks

When it may not be suitable

This cable is designed for CAT6 performance and typical indoor networking environments; it is not intended for permanent outdoor burial or direct exposure to sunlight without additional protection. It also may be unnecessary for simple legacy 100Base‑T installations where CAT5e would suffice.

Key specifications

• Category: CAT6
• Shielding: S/FTP (individual foil on pairs + overall braid)
• Length: 2 m
• Conductor: AWG 26 stranded
• Jacket material: PVC
• Insulation: polyethylene
• Connector type: RJ45 to RJ45
• Contact plating: 50 μin gold
• Boot: molded, snag‑proof, slim design
• Operating temperature: -20 °C to 60 °C
• Storage temperature: -20 °C to 60 °C
• Maximum operating humidity: 93%

How to use

Plug the RJ45 connector into the network port of your device and the other end into a switch, router, or patch panel. Ensure connectors are fully inserted until the latch clicks. Route the cable without sharp bends and avoid running it parallel and close to high‑voltage power lines to minimize interference. For high‑density installations, the slim molded boot allows side‑by‑side connections without blocking adjacent ports.

What to consider before purchase

• Required length and whether 2 m suits your setup
• Need for shielded cable (S/FTP) depending on local electromagnetic interference
• Compatibility with device ports and clearance in high‑density panels
• Indoor use suitability due to PVC jacket (not for direct outdoor burial)

Usage recommendations

For best performance, use the cable within the specified temperature and humidity ranges, avoid tight bends at the connector, and pair it with CAT6‑rated patch panels and switches to maintain expected data rates and signal integrity.