Chain Guide 35 cm 1.3 mm 3/8" for chainsaw — Sourcing (MPN 191G33-9)

The Sourcing chain guide bar with a 35 cm length, 1.3 mm gauge and 3/8" pitch is a replacement guide designed for small to mid-size chainsaws. It holds and aligns a compatible saw chain to ensure consistent cutting performance. The guide bar is intended for routine maintenance and blade replacement when the gauge and pitch match the existing chain and sprocket dimensions.

Advantages

This guide bar provides accurate chain alignment and stable tracking along the bar groove, which supports smoother cuts and helps reduce premature wear on the chain. Its 35 cm length balances reach and maneuverability for general cutting tasks, while the 1.3 mm gauge and 3/8" pitch compatibility make it suitable for many lightweight and mid-range chainsaw models. The bar's construction is optimized for everyday forestry and garden work where reliable guidance and proper chain fit are required.

Suitable for

• Timber cutting of small to medium-sized logs
• Pruning and trimming in gardens and orchards
• General forestry maintenance and firewood preparation
• Replacement during chainsaw maintenance when chain gauge is 1.3 mm and pitch is 3/8"

Key specifications

• Guide bar length: 35 cm
• Chain gauge (thickness): 1.3 mm
• Chain pitch: 3/8"
• Intended use: replacement guide bar for compatible chainsaws
• Typical fitment: small to mid-size chainsaw models requiring 35 cm bar

How to use

Before installation, confirm that the chainsaw chain pitch and gauge match the guide bar specifications and that the sprocket style is compatible. Remove the old bar and chain following the chainsaw manufacturer's safety procedures, including disconnecting power or ignition and wearing protective gloves. Mount the new guide bar onto the guide stud, loop the correctly sized chain into the bar groove, and adjust chain tension to the manufacturer's recommended setting. After installation, run the saw at low throttle to check chain tracking and tension again, and re-tension if necessary.

Usage recommendations

Use the guide bar only with chains that match the 1.3 mm gauge and 3/8" pitch to prevent improper fit and accelerated wear. Regularly inspect the bar groove for debris and wear, keep the chain properly sharpened and lubricated, and follow the chainsaw manufacturer's maintenance schedule to ensure safe and reliable operation.