Underfloor Heating Mat Sourcing HEATING MAT 150 W/m² 6.0 m²

Sourcing HEATING MAT 150 W/m² 6.0 m² is a pre-wired electric underfloor heating mat designed to provide even radiant warmth beneath tile, natural stone or other suitable floor coverings. With a rated power density of 150 W per square metre and a total mat coverage of 6.0 m², the product is intended for residential and light commercial applications where controlled surface heating is required. The mat arrives ready for installation and is suitable for use in renovation projects and new constructions where a low-profile, evenly distributed heat source is preferred.

Advantages

The pre-wired construction simplifies installation by reducing the amount of on-site wiring and connection work. The specified power density of 150 W/m² offers responsive surface heating that can reach comfortable floor temperatures more quickly than lower-density systems. Because it is designed for direct installation under tile and stone floors, the mat creates uniform heat distribution across the covered area and minimizes local cold spots. The low-profile design makes it suitable for retrofit installations where floor build-up must be kept to a minimum.

Suitable for

• Bathroom floors beneath tile or stone
• Kitchen and utility room areas with suitable floor coverings
• Renovation projects requiring minimal floor height increase
• New build rooms where even surface heating is desired

Key specifications

• Power density: 150 W/m²
• Total coverage area: 6.0 m²
• Type: pre-wired underfloor heating mat
• Intended floor coverings: tile, natural stone, and other heat-compatible surfaces
• Application: indoor residential and light commercial spaces

How to use

Install the Sourcing heating mat on a clean, level subfloor following applicable local regulations and the manufacturer’s installation instructions. Lay the mat evenly across the intended coverage area, cut and turn the mesh only—not the heating cable—so that the heating cable runs at the specified spacing. Fix the mat according to recommended methods, apply the appropriate thinset or levelling compound over the mat, and then install the final floor covering such as tile or stone. Connect the mat to a suitable thermostat and power supply; electrical connections should be performed by a qualified electrician and tested before commissioning.

Usage recommendations

Use a thermostat with floor temperature sensing and appropriate load rating to control the system efficiently. Verify compatibility of adhesives and leveling compounds with electric underfloor heating and ensure insulation and substrate preparation meet local building codes to optimize performance and energy use.