Fibre Optic Cable ALLNET S216204 5m LC Grey Orange White

The ALLNET S216204 5m OM2 fibre optic cable with LC connectors on both ends provides a standardized multimode link for short- to medium-range data transmission. With a 50 µm core diameter and full-duplex capability, this grey-orange-white cable supports common networking equipment in data centers, server rooms and telecom closets. The cable is built to deliver low-loss connections between devices that accept LC terminations, enabling predictable optical performance for enterprise networks and structured-cabling installations.

Advantages

This OM2 fibre cable combines a standardized 50 µm multimode core with LC-to-LC terminations for compact connector footprint and easy handling. The full-duplex configuration supports simultaneous bidirectional transmission and the 5 m length gives flexibility for rack-to-rack or equipment-to-patch-panel connections. Colour coding (grey, orange, white) facilitates identification in dense cabling environments while the factory-terminated LC ferrules ensure consistent insertion loss and repeatable mating performance.

Подходит для

• Соединение серверов с коммутаторами и оптическими панелями
• Инфраструктура дата-центров и стойковые компоновки
• Сетевые отсеки и серверные помещения
• Тестирование и временные соединения при обслуживании оборудования

Key specifications

• Fibre type: multimode (OM2)
• Core diameter: 50 µm
• Connector type: LC to LC (both ends)
• Length: 5 m
• Transmission mode: full duplex
• Cable colours: grey / orange / white

How to use

Route the fibre optic cable between equipment ports that accept LC connectors, avoiding tight bends and securing the run to prevent strain on the connectors. Remove protective caps from the LC ferrules immediately before insertion. Connect each LC plug into the corresponding LC socket until it clicks into place, and verify link status on the connected devices. For moves or changes, unplug by depressing the LC latch and pulling straight out; always replace protective caps when the cable is not in use to protect the ferrule endface.

Usage recommendations

Keep bend radii above manufacturer-recommended limits (avoid bends tighter than 10 mm for typical multimode cables), maintain clean endfaces by using approved fibre cleaning tools, and label both ends to match rack and patch-panel documentation. Use the 5 m length for intra-rack and near-rack connections to minimize excess slack in high-density environments.