Network patch cable Synergy21 RJ45 CAT6A 500 MHz S-STP Outdoor PE/PVC UV- and water-resistant 3 m AWG26

Shielded Synergy21 RJ45 CAT6A patch cable designed for up to 500 MHz performance. The S‑STP construction, with individually shielded pairs and an overall shield, together with AWG26 conductors, supports reliable high-speed Ethernet connections. A durable dual-material outer jacket (PE for the outdoor section and PVC where applicable) is UV- and water-resistant for use in exposed outdoor runs and transitional indoor/outdoor installations. The 3 m length is suitable for connecting network devices, switches and patch panels where a short, shielded link is required.

Advantages

The shielded S‑STP design reduces electromagnetic interference and improves signal integrity in environments with substantial electrical noise. AWG26 conductors provide a balance between flexibility and low attenuation for 10/100/1000 Mbps and 10 Gbps over short distances. The PE/PVC outer jacket offers mechanical protection and resistance to sunlight and moisture, extending service life when routed outdoors or through semi-exposed pathways.

Suitable for

• Connecting switches, routers, patch panels and network devices within racks or cabinets
• Short outdoor or indoor/outdoor runs where UV and water resistance is required
• Environments with electrical interference where shielding improves link stability
• Installations requiring CAT6A performance up to 500 MHz and 10GBase-T over short distances

When it may not be suitable

This 3 m patch cable is not intended for long-distance backbone cabling or runs that exceed CAT6A distance limitations for 10GBase-T (typically 100 m overall channel). It may not be the best choice where a completely flexible, low-profile indoor-only cable is required, as the outdoor-grade jacket and shielding increase stiffness compared with unshielded patch cords.

Key specifications

• Cable category: CAT6A, suitable for frequencies up to 500 MHz
• Shielding: S‑STP (individually shielded pairs + overall shield)
• Conductor size: AWG26 solid or stranded conductors (as typical for patch cables)
• Length: 3 m
• Outer jacket: PE/PVC combination designed for UV and water resistance
• Connectors: RJ45 terminated on both ends
• Environmental rating: outdoor-capable jacket with UV and moisture resistance

How to use

Route the Synergy21 RJ45 CAT6A patch cable between the two network endpoints, ensuring connectors are fully seated into RJ45 ports until they click. When used outdoors or in semi-exposed locations, avoid sharp bends and protect termination points from direct water ingress; use appropriate weatherproofing at wall entries or patch panels. Keep the cable away from sources of high power electromagnetic interference where possible, although shielding will mitigate many interference sources.

What to consider before purchase

• Required length — ensure 3 m is sufficient for the intended run plus slack for connections
• Shielding needs — S‑STP is beneficial in high-interference environments but requires properly grounded equipment
• Installation environment — outdoor-capable jacket resists UV and moisture but check local routing and protection requirements
• Performance expectations — CAT6A supports up to 500 MHz; verify channel components to achieve intended speeds

Usage recommendations

For best results, terminate the cable into shielded RJ45 ports or use shielded patch panels and ensure proper grounding of the shield. Avoid tight bends (maintain manufacturer recommended bend radius) and secure cables to prevent strain on the connectors when installed in outdoor or semi-exposed locations.