Patch cable Synergy21 RJ45 CAT6A 500MHz S/FTP Outdoor AWG26 30m

Shielded Synergy21 RJ45 patch cable CAT6A 500MHz, S/FTP construction, 30 m length and AWG26 conductors provide a durable outdoor-ready connection for high-speed Ethernet links. The cable features individual pair foil shielding combined with an overall braided shield to reduce crosstalk and electromagnetic interference (EMI). Designed for applications that require Category 6A performance up to 500 MHz, this patch cable supports elevated data rates and stable signal transmission across longer runs typical of outdoor or exposed installations.

Advantages

The S/FTP design—foil around each twisted pair plus an overall braid—minimizes near-end and far-end crosstalk and improves immunity to external interference from power lines, wireless devices or other nearby cables. AWG26 conductors balance flexibility and conductor cross-section for reliable signal integrity, while the 30 m length reduces the need for additional links or couplers in many outdoor deployments. The construction is intended for outdoor network runs where shielding and mechanical robustness are important for maintaining consistent Ethernet performance.

Suitable for

• Outdoor Ethernet links between buildings, cabinets or access points
• High-speed 1G/10G Ethernet networks requiring CAT6A performance
• Environments with elevated electromagnetic interference where shielded cables are preferred
• Backbone or horizontal runs that need a single continuous 30 m cable

When it may not be suitable

This shielded CAT6A S/FTP cable may be unnecessary for short indoor runs where unshielded CAT5e/CAT6 cables provide sufficient performance and lower cost. In installations where electrical grounding of the shield is not practical or where connectors and network devices do not support shield termination, the benefits of shielding may not be realized. For aerial installations or direct burial, check specific mechanical and environmental ratings beyond standard outdoor suitability.

Key specifications

• Category: CAT6A, performance up to 500 MHz
• Shielding: S/FTP (individual pair foil + overall braid)
• Conductor size: AWG26
• Length: 30 m
• Connector type: RJ45 (shielded connectors recommended for full benefit)
• Intended use: Outdoor network runs and high-speed Ethernet links

How to use

Install the Synergy21 shielded RJ45 patch cable by routing it along the planned outdoor path, avoiding sharp bends and mechanical stress. Terminate or connect to shielded RJ45 ports or use shielded patch panels and connectors to ensure the braided shield is properly grounded at one or both ends as required by the installation. For best performance, maintain proper bend radius, avoid running parallel to high-voltage power lines where possible, and secure the cable to prevent movement and wear. Verify link speed and signal integrity after installation using network test equipment appropriate for CAT6A cabling.

What to consider before purchase

• Whether shielded cabling is required and if your devices/patch panels support shield termination
• Compatibility with the intended Ethernet speed (e.g., 1G, 10G) and link distance
• Environmental requirements such as UV resistance, temperature range, and mechanical protection for outdoor routing
• Whether a single 30 m length matches your run or if additional cable/patching will be needed

Usage recommendations

For optimal EMI protection, ground the cable shield at designated grounding points and use shielded RJ45 connectors or patch panels. Test the installed link with a CAT6A-capable tester to confirm performance up to 500 MHz and correct shielding continuity. Avoid tight bends and secure the cable to prevent abrasion or moisture ingress in outdoor installations.