Patch Cable Synergy21 RJ45 CAT6A 500MHz S-STP (S/FTP) Outdoor UV- and water-resistant AWG26 40m

The Synergy21 RJ45 CAT6A patch cable is a shielded Ethernet cable designed for demanding outdoor network installations. With CAT6A performance up to 500 MHz and S-STP (S/FTP) construction, the cable combines overall braid shielding with individual pair foil shields to reduce electromagnetic interference. AWG26 solid conductors ensure reliable signal transmission over the 40 m length, while a UV- and water-resistant outer jacket provides mechanical and environmental protection for exterior use.

Advantages

The cable’s S-STP (S/FTP) shielding offers enhanced protection against crosstalk and external EMI compared with unshielded or foil-only designs. CAT6A 500 MHz rating supports higher data rates and longer runs for 10 Gigabit Ethernet applications where interference control is important. The outdoor-grade jacket resists UV exposure and moisture, making the cable suitable for direct routing in outdoor conduits, on facades, or between buildings. AWG26 conductors balance flexibility and electrical performance for consistent throughput across the 40 m length.

Suitable for (tasks / use cases)

• Outdoor network runs between buildings or to external network points
• 10 Gigabit Ethernet installations requiring CAT6A performance
• Power over Ethernet (PoE/PoE+) deployments where shielding reduces interference
• Environments with elevated electromagnetic interference such as near electrical equipment

When it may not be suitable

This shielded CAT6A cable is not the best choice for purely indoor, concealed wiring where a thinner, unshielded cable would be easier to route and terminate. In installations where connectors or patch panels do not support cable shielding termination, the benefits of S-STP may be limited. For runs significantly longer than 40 m, consider link design and certified channel lengths for the intended Ethernet speed.

Key specifications

• Category: CAT6A, performance up to 500 MHz
• Shielding: S-STP (overall braid + individual pair foil)
• Conductor: AWG26 (solid conductors)
• Length: 40 m
• Jacket: outdoor-grade, UV- and water-resistant
• Connector: RJ45 (shielded termination recommended)

How to use

Route the cable along the planned outdoor path, securing it with appropriate clips or conduit to avoid mechanical strain. Use shielded RJ45 connectors and a compatible shielded patch panel or metal chassis to maintain the continuity of the braid shielding; terminate shielding according to best practices to avoid ground loops. Test the installed link with a network tester that verifies CAT6A performance and continuity over 10 Gbps channels if required. For PoE deployments, confirm connector and end-device compatibility with the intended power level.

What to consider before purchase

• Verify that both ends of the network channel (patch panels, switches) can accept and properly terminate shielded cable
• Confirm that 40 m length meets your run requirements and that overall channel length remains within standards for the chosen Ethernet speed
• Assess environmental exposure (direct sunlight, standing water, chemical exposure) to ensure the jacket rating is sufficient
• Ensure connectors and installation accessories are rated for outdoor use if terminations will be exposed

Usage recommendations

For best results, terminate the Synergy21 CAT6A S-STP cable using shielded RJ45 plugs and bond the cable shield to a single earth point at one end. Use conduit or UV-stable fasteners for exposed runs and test each link after installation to confirm CAT6A performance and PoE compatibility.