Leave your address - as soon as the price of the product goes down, you'll know about it right away
Fiber optic cable TECHLY LC–LC multimode OM3 50/125 µm, 10 m, full duplex
Fiber optic cable TECHLY LC–LC multimode OM3 50/125 µm, 10 m, full duplex
In cart {{totalProductsCount}} item(s)
Your cart is empty
Fiber optic cable TECHLY LC–LC multimode OM3 50/125 µm, 10 m, full duplex
Leave your address - as soon as the price of the product goes down, you'll know about it right away
Fiber optic cable TECHLY LC–LC multimode OM3 50/125 µm, 10 m, full duplex
Fiber optic cable TECHLY LC–LC multimode OM3 50/125 µm, 10 m, full duplex
Fiber optic cable TECHLY LC–LC multimode OM3 50/125 µm, 10 m, full duplex is a multimode patch cable with LC connectors on both ends, designed for short- to medium-range high-speed links. The cable uses OM3 50/125 µm multimode glass, a jacket with a 3.0 mm outer diameter and an aqua colour, and is intended for full-duplex transmission in LANs, data centers and audiovisual installations. With LC–LC terminations and a 10 m length, it is suitable for patching, uplinks and direct device-to-device connections that require LC connectors and multimode performance.
This TECHLY OM3 multimode LC–LC cable supports 10 Gbit/s transmission over multimode fibre and delivers higher modal bandwidth compared with lower-grade multimode cables, enabling longer reach for high-speed links. The LC connectors provide compact duplex terminations for high-density panels and devices. The 10 m length offers flexibility for rack-to-rack or rack-to-equipment connections while the cable's construction and jacket diameter ensure straightforward handling and routing in typical installation environments.
Install the TECHLY LC–LC OM3 cable by inserting each LC connector into the corresponding LC duplex adapter or module on patch panels, switches or optical transceivers. Ensure connectors are clean before mating to prevent signal loss; use appropriate dust caps when connectors are not in use. Route the cable without sharp bends and avoid tensile strain; maintain bend radii recommended for multimode fibre during installation. For best performance, verify link operation with suitable testing equipment after installation.
For consistent performance, keep connector endfaces clean and avoid tight bends or crushing. Use this OM3 LC–LC cable for indoor installations and structured cabling where LSZH jackets are required. When testing or certifying links, follow industry test procedures for multimode OM3 fibres.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}