Network patch cable Telegärtner CAT6a 50m S/FTP (S‑STP) RJ‑45 to RJ‑45, red

Telegärtner CAT6a network patch cable, 50 m in length, equipped with S/FTP (S‑STP) shielding and factory‑terminated RJ‑45 connectors at both ends. Engineered to meet Cat6a performance, this red patch cable supports high‑speed Ethernet and structured cabling installations where reduced crosstalk and electromagnetic interference are required. The cable is suitable for horizontal and vertical cabling runs in LANs, office environments and data centers.

Advantages

The S/FTP (S‑STP) shielding combines an overall foil shield with individually foil‑shielded pairs to provide enhanced protection against external electromagnetic interference and pair‑to‑pair crosstalk. Factory‑terminated RJ‑45 plugs ensure consistent terminations and predictable performance without the need for on‑site connector assembly. A 50 m length provides extended reach for larger rooms or runs between racks and patch panels while the Cat6a specification supports higher data rates and improved alien crosstalk resistance compared with lower category cables.

Suitable for

• Gigabit and 10 Gigabit Ethernet links in LAN and data centre environments
• Structured cabling between patch panels, switches and wall outlets
• Office network installations requiring shielded cabling to minimise interference
• Applications where a 50 m pre‑terminated cable run simplifies installation

When it may not be suitable

This cable may not be necessary for very short runs where Cat5e or Cat6 cables already meet speed and shielding requirements. It may also be excessive for consumer home networks that do not require Cat6a performance or additional shielding. Where conduit space is extremely limited, the cable diameter and shielding construction should be checked to ensure proper fit.

Key specifications

• Cable category: Cat6a
• Shielding: S/FTP (overall foil + individually foil‑shielded pairs)
• Connectors: RJ‑45 to RJ‑45, factory‑terminated
• Length: 50 m
• Color: red
• Application: horizontal and patch cabling for Ethernet up to 10 Gbps (Cat6a performance)

How to use

Uncoil the 50 m cable carefully to avoid kinks and stress on the conductors. Connect one RJ‑45 end to the network switch, patch panel or outlet and the other end to the corresponding device or panel. Ensure connectors are fully seated and latched. For permanent installations route the cable according to site standards, avoiding close parallel runs with power cabling where possible. Verify network link and performance using appropriate test equipment after installation.

What to consider before purchase

• Verify that Cat6a performance and shielding are required for your network speeds and environment
• Confirm that a 50 m pre‑terminated fixed length matches your planned cable routing
• Check that the red color and cable diameter suit identification and physical routing constraints
• Ensure connectors are compatible with your equipment's RJ‑45 ports

Usage recommendations

For best performance, avoid sharp bends and excessive tension; maintain recommended bend radius and separate from high‑power electrical cabling. Use appropriate cable management and strain relief at termination points and test the installed link to confirm Cat6a performance and shielding effectiveness.