PoE adapter TRENDNET TPE-114GS — Gigabit Ethernet, 48 V PoE, 10/100/1000 Mbps

TRENDNET TPE-114GS is a compact PoE adapter designed for Gigabit Ethernet environments. It accepts a 48 V Power over Ethernet input and splits the signal into separate Gigabit data and DC power outputs, enabling installation of non‑PoE devices in locations without a nearby power outlet. The adapter supports data rates of 10/100/1000 Mbps over standard twisted‑pair cabling and includes a basic LED power indicator and CE/FCC certification. Its small form factor and short‑circuit protection make it suitable for small installations where a reliable 48 V PoE source must be converted for end devices.

Advantages

The TRENDNET TPE-114GS provides a simple way to convert 48 V PoE to separate power and gigabit data lines without additional power supplies. It supports full Gigabit data throughput (10/100/1000 Mbps) and reduces installation cost by allowing remote placement of non‑PoE devices up to 100 meters from a PoE switch or injector. A multi‑position toggle allows selection of common DC output voltages to match device requirements, and built‑in short‑circuit protection helps safeguard connected equipment.

Suitable for (tasks / use cases)

• Powering non‑PoE IP cameras from a Gigabit PoE switch or injector
• Connecting access points or wireless devices that require separate DC power
• Installing networked devices in locations without AC power outlets
• Deployments requiring Gigabit data rates with separated DC power

Key specifications

• PoE input voltage: 48 V
• Data rates: 10/100/1000 Mbps (Gigabit Ethernet)
• Supported cabling: 10/100/1000Base‑T(X) twisted‑pair Ethernet
• Selectable DC output voltages: 5 V, 7.5 V, 9 V, 12 V
• Short‑circuit protection for DC output
• Indicator: basic LED power status
• Weight: 0.065 kg
• Certifications: CE, FCC

How to use

Run an Ethernet cable from a Gigabit PoE switch or PoE injector to the TRENDNET TPE-114GS at the remote location, observing standard Ethernet maximum run length of up to 100 meters. Use the adapter's RJ‑45 input for the PoE connection; the device will separate the incoming PoE into a Gigabit data output and a DC power output. Set the toggle switch to the required DC voltage (5 V, 7.5 V, 9 V, or 12 V) that matches the target device's power specification, then connect the device to the DC output and the data output to its network port. Verify the LED power indicator to confirm power presence before powering the end device.

Usage recommendations

Use the TRENDNET TPE-114GS with compatible Gigabit PoE sources that supply 48 V and ensure the selected DC output voltage matches the non‑PoE device requirements. Do not exceed the recommended cable length for reliable Gigabit performance, and install the splitter in a dry, ventilated location. If unsure about voltage selection or device compatibility, consult the device’s power documentation before connection.