Networking cable Triton 21.99.1964 Cat6a S/FTP (S-STP) RJ‑45 to RJ‑45 0.3 m Black

Triton 21.99.1964 Cat6a S/FTP (S‑STP) RJ‑45 to RJ‑45 0.3 m in black is a short patch cable designed for high‑speed Ethernet links in confined installation spaces. The cable uses Cat6a class wiring with S/FTP shielding (pair foil plus overall braid) and RJ‑45 connectors on both ends, enabling reliable connections between network devices, switches and patch panels. It supports data transfer rates up to 10 Gbit/s and a bandwidth of 500 MHz while maintaining a 100 Ω impedance and EIA/TIA 568 1:1 contact wiring.

Advantages

The S/FTP shielding provides robust protection against electromagnetic interference and crosstalk, making the cable suitable for environments with multiple adjacent signal sources. The moulded kink protection on each connector improves connector durability and reduces stress at termination points. A flexible jacket and compact 0.3 m length allow easy routing in tight spaces behind racks, patch panels or within enclosures. The standard black jacket matches typical data center and office installations.

Suitable for

• Short interconnects between switches, patch panels and network devices
• 10 Gigabit Ethernet links over short distances
• Enclosed or space‑constrained installations in racks and cabinets
• Shielded network environments where EMI reduction is required

Key specifications

• Cable category: Cat6a
• Shielding: S/FTP (pair foil with overall braided shield)
• Connector type: RJ‑45 to RJ‑45
• Length: 0.3 m
• Impedance: 100 Ω
• Maximum data rate: up to 10 Gbit/s
• Bandwidth: 500 MHz
• Conductor configuration: 8 conductors, twisted pairs
• Contact wiring: 1:1 (EIA/TIA 568)
• Jacket colour: black

How to use

Connect each RJ‑45 plug to the corresponding network ports on devices, switches or patch panels until the latch clicks into place. Ensure both ends are fully seated to maintain proper contact and shielding continuity. Route the cable to avoid tight repeated bending and keep it clear of potential sources of mechanical stress. For best performance, use this short patch cable for direct device-to-switch or patch panel connections within the same rack or cabinet.

Usage recommendations

To preserve shielding effectiveness and signal quality, ground the connected equipment according to site practices and avoid routing the cable parallel and close to unshielded power lines. For reliable 10 Gbit/s operation, limit runs to typical short interconnect distances and verify port settings on network equipment to match Cat6a capabilities.