Flexible stainless steel water connector TUCAI TAQ-GRIF H1/2-M10x1 long end L=30 cm

Flexible stainless steel water connector TUCAI TAQ-GRIF H1/2-M10x1 long end L=30 cm is a braided hose designed for potable water installations and appliance connections. The connector pairs an H1/2 threaded interface with an M10x1 fitting and features a 30 cm length that helps reach fixtures in confined or recessed spaces. Constructed with corrosion-resistant stainless steel braid, it is intended for reliable water delivery to sinks, faucets, boilers and other water fixtures where a compact, flexible link is required.

Advantages

The stainless steel braided exterior provides enhanced resistance to corrosion and abrasion compared with plain rubber hoses, while the flexible construction simplifies installation in tight or awkward positions. Threaded H1/2 and M10x1 connections enable compatibility with a range of valves and appliance inlets, and the 30 cm length balances reach with compact routing to minimize kinking. The design supports potable water use and is suitable for domestic and light commercial plumbing applications.

Suitable for

• Connecting faucets and sink fixtures to water supply valves
• Supplying water to boilers and water heaters with M10x1 inlets
• Replacing worn or rigid connectors in tight installation spaces
• Use in kitchens, bathrooms and utility rooms where a short flexible link is needed

Key specifications

• Materials: stainless steel braided hose with inner flexible tube
• Connections: H1/2 threaded female side and M10x1 male/female interface as specified
• Length: 30 cm (overall working length)
• Use: potable (drinking) water installations
• Design: long end configuration to allow access in recessed fittings

How to use

Before installation, shut off the water supply and relieve pressure by opening a downstream tap. Check thread types on both the valve and appliance to ensure H1/2 and M10x1 compatibility. Hand-start the threads to avoid cross-threading, then tighten to manufacturer-recommended torque using suitable tools; avoid over-tightening which can damage fittings. After fitting the connector, slowly restore water supply and inspect all joints for leaks. If any leaks appear, isolate the water, retighten connections and retest.

Usage recommendations

For long service life, avoid sharp bends and ensure the hose is routed without excessive twisting or compression. Periodically inspect the braided surface and connections for signs of wear or corrosion and replace the connector if damage is detected. Use appropriate washers or sealing elements where required by the mating fittings and follow local plumbing codes for potable water installations.