Unidelta elbow PE to male threaded 32 mm x 5/4" 602533

Unidelta elbow PE to male threaded 32 mm x 5/4" is a polyethylene (PE) elbow designed to join a 32 mm PE pipe to a 5/4" male threaded fitting. The fitting provides a 90° change of direction for water and low-pressure fluid systems, enabling transitions between smooth-bore PE pipework and threaded components such as valves, taps or metal fittings. Constructed for compatibility with common plumbing and irrigation layouts, the elbow supports straightforward assembly where a threaded termination is required.

Advantages

The elbow combines a corrosion-resistant PE body with a precision-machined male thread to ensure leak-minimised connections when installed correctly. Its compact 90° design reduces routing space and simplifies direction changes in tight installations. The material properties of polyethylene provide chemical resistance and flexibility to accommodate standard PE pipe joining procedures while limiting weight and installation complexity.

Suitable for (tasks / use cases)

• Connecting 32 mm PE distribution lines to threaded valves and taps
• Domestic and agricultural irrigation systems with mixed-material fittings
• Low-pressure potable water applications where a threaded connection is required
• Utility and maintenance pipe transitions between PE and metal threaded components

Key specifications

• Body material: polyethylene (PE)
• Connection A: 32 mm socket for PE pipe
• Connection B: 5/4" male thread
• Angle: 90° elbow
• Typical application pressure: low-pressure water and fluid systems (as per system design)
• Compatibility: suitable for use with standard 32 mm PE pipes and standard 5/4" threaded fittings

How to use

Prepare the PE pipe end by cutting square and removing burrs, then insert the pipe into the 32 mm socket according to the chosen joining method for PE (mechanical compression, electrofusion or appropriate solvent/weld procedure if applicable). Ensure the male threaded end is sealed using suitable thread sealant tape or jointing compound before engaging with the mating female thread. Tighten to the torque recommended for the mating component, avoiding over-tightening that could deform the PE body or damage threads. After assembly, test the connection under system pressure to confirm there are no leaks.

Usage recommendations

Use the elbow only within the pressure and temperature limits of the overall piping system and follow manufacturer guidance for PE pipe joining methods. For potable water installations verify compatibility of thread sealants with drinking-water standards. Avoid exposing threaded connections to excessive mechanical stress or impact; provide support near the fitting to minimise bending loads on the joint.