Connection Cord 6 m for Unify optiPoint — RJ11 to RJ11 telephone cable

Connection Cord 6 m for Unify optiPoint — RJ11 to RJ11 telephone cable is a 6-metre lead designed to connect Unify optiPoint desk telephones to wall sockets or base units. The cable features RJ11 connectors on both ends and is intended for standard analog and ISDN telephone installations where a longer reach is required. It is compatible with typical desktop telephony setups and provides a straightforward wired connection for voice communication devices.

Advantages

The 6 m length allows flexible placement of desk phones away from wall outlets without requiring additional adapters. RJ11 connectors on both ends ensure reliable, low-complexity connectivity with standard analog and ISDN ports. The cord is designed for straightforward installation and stable signal transmission suitable for office and home telephony environments.

Suitable for

• Connecting Unify optiPoint desk telephones to wall sockets
• Linking desk phones to base units or telephone adaptors
• Extending reach in office phone installations
• Home telephony setups requiring a 6 m RJ11 cable

Key specifications

• Cable length: 6 metres
• Connector type: RJ11 on both ends
• Supported connection types: standard analog and ISDN telephone lines
• Application: desk phone to wall socket or base unit

How to use

Insert one RJ11 connector into the socket on the Unify optiPoint desk telephone and the other into the wall-mounted telephone socket or base unit. Ensure connectors are fully seated to establish a secure connection. Route the cable to avoid sharp bends and pinching points to maintain signal quality. If extending an existing installation, disconnect power to affected equipment where recommended by the device manufacturer before plugging or unplugging the cable.

Usage recommendations

For best results, route the cable along walls or under desks to minimize tripping hazards and mechanical stress. Avoid running the phone cord parallel and close to power cables for long distances to reduce potential interference. Inspect connectors for debris before insertion and replace the cord if insulation or connectors show signs of wear.