S/FTP Patch Cord Cat.6 VALUE 1.5m

VALUE S/FTP Patch Cord Cat.6 1.5m is a shielded twisted pair patch cable with RJ-45 connectors on both ends, intended for use as a patch cable in wiring cabinets or as a direct connection between devices. The 1.5 meter flexible cable uses 8 stranded copper conductors with braided shielding and an LSOH (Low Smoke Zero Halogen) jacket. The contact wiring is 1:1 according to EIA/TIA 568 and the cable has a characteristic impedance of 100 Ohm. The cable and connector combination has been tested in our laboratory in a 100 m channel and complies with Class E specifications.

Advantages

The S/FTP construction provides enhanced protection against electromagnetic interference, while the braided shield improves overall signal integrity. The flexible, narrow-bend design makes the 1.5 m cable easy to route in dense racks and confined spaces. The LSOH outer jacket reduces smoke emission and contains no halogens, increasing safety in enclosed environments. Standard RJ-45 termination and EIA/TIA 568 1:1 pinout ensure broad compatibility with networking equipment.

Suitable for

• Connecting network devices in wiring cabinets and patch panels
• Direct device-to-device Ethernet connections over short runs
• Office and data center horizontal and patching installations
• Environments where low-smoke, halogen-free cabling is required

Key specifications

• Type: S/FTP (shielded, braided shield with foil pairs)
• Category: Cat.6, Class E compliant (tested in 100 m channel)
• Length: 1.5 m
• Conductors: 8 stranded copper wires
• Impedance: 100 Ohm
• Connector: RJ-45, 1:1 wiring (EIA/TIA 568)
• Jacket: LSOH (Low Smoke Zero Halogen)
• Brand/MPN/EAN: VALUE / 21.99.0715 / 7611990113729

How to use

Plug the RJ-45 connectors into the corresponding ports on network devices, switches, patch panels or wall jacks. Route the cable without sharp bends; the flexible construction allows tight routing but avoid exceeding the manufacturer’s minimum bend radius. Use the cable as part of a structured cabling channel together with compatible Cat.6 components (shielded jacks, patch panels, and solid S/FTP cable) to maintain Class E performance.

Usage recommendations

For structured installations, combine this VALUE S/FTP Patch Cord Cat.6 with shielded Cat.6 components (shielded wall jacks and patch panels) and solid S/FTP cable to ensure full shielding continuity and Class E compliance across the channel.