Drainage hose for submersible pumps VARTCO 1" (25 mm) — 20 m, model 1111250020

Flexible drainage hose for submersible pumps VARTCO with a nominal inner diameter of 1" (25 mm) and a total length of 20 m, model 1111250020. The hose is intended to transport water and wastewater from basins, wells or flooded areas when connected to submersible or utility pumps. It is constructed to resist kinking during operation and withstand typical abrasion caused by pump discharge, while remaining compatible with standard 1" pump outlets.

Advantages

The hose combines flexibility and dimensional stability to ensure continuous flow without frequent re-routing. Its abrasion-resistant inner surface reduces wear when handling particulates commonly found in drainage and sump pump applications. Lightweight construction and compatibility with standard 1" fittings make it easy to connect and deploy for temporary or semi-permanent drainage tasks.

Suitable for

• Draining flooded basements, cellars and low-lying areas
• Pumping water from wells, sumps and cisterns
• Temporary site dewatering on construction sites
• Garden and irrigation runoff management
• Emergency water removal for household or light commercial pumps

Key specifications

• Inner diameter: 1" (25 mm)
• Length: 20 m
• Material characteristics: flexible, abrasion-resistant inner surface
• Compatibility: designed for use with standard 1" pump outlets
• Operational use: suitable for water and wastewater conveyance

How to use

Connect one end of the hose securely to the pump outlet using the appropriate 1" fitting or clamp. Lay the hose along a clear discharge route to avoid sharp bends and kinks that could restrict flow. During operation, periodically inspect the hose for signs of abrasion or external damage and reposition as needed to maintain an unobstructed path. After use, drain residual water from the hose, coil it loosely and store it in a dry place away from direct sunlight to prolong service life.

Usage recommendations

Use the hose within the pressure and temperature limits of the connected pump. Avoid dragging the hose over sharp edges and remove large debris from the intake area before operation to minimize internal abrasion. For semi-permanent installations, support the hose at intervals to prevent sagging and reduce stress on fittings.