Washer for pump 2" / 50 mm, 20 m roll, VARTCO 1111500020

VARTCO 2" / 50 mm washer roll supplied in a 20 m length provides a continuous sealing strip intended for threaded pump joints and pipe connections. Made to fit 2-inch (50 mm) fittings, this washer roll is designed for creating reliable seals in water pump installations and general plumbing tasks where a strip-style gasket is preferable to individual rings. The roll format allows cutting custom lengths on site and reduces the need to carry multiple pre-cut washers.

Advantages

The 20 m roll format ensures an uninterrupted supply of sealing material, reducing waste and simplifying inventory for technicians. A consistent 50 mm width is matched to standard 2" pump fittings for accurate coverage of the contact surface. The flexible washer material adapts to irregularities in threads and joints, improving sealing performance and helping to prevent leaks in water pump and plumbing systems.

Suitable for

• Sealing threaded connections on 2" (50 mm) water pumps
• Creating custom-length gaskets for pipe joints and flanges
• Maintenance and repair tasks in domestic and small industrial plumbing
• Situations requiring on-site cutting of washer strips to non-standard lengths

Key specifications

• Width: 50 mm (2 inches)
• Length: 20 m roll
• Form: continuous washer strip (roll)
• Intended application: sealing pump and pipe threaded joints
• Compatibility: designed for 2"/50 mm fittings and connections

How to use

Measure the joint or threaded connection to determine the required length, then cut the washer strip from the roll with scissors or a utility knife. Wrap or apply the strip around the male thread or position it between mating surfaces so the washer fully covers the sealing area. Reassemble the joint and tighten to the recommended torque for the fitting; inspect for leaks after pressurizing the system. For repeated installations, store the roll in a dry place away from direct sunlight.

Usage recommendations

For optimal sealing, ensure mating surfaces are clean and free of debris before applying the washer strip. Use only lengths that fully cover the contact area without excessive overlap, and verify compatibility with the fluid and temperature conditions of the installation.