Sealing Strip (lower) Vendita UDWI8 8 mm clear, 1.6 m, single piece

Sealing Strip (lower) Vendita UDWI8 8 mm clear, 1.6 m, single piece is a transparent lower seal designed for walk-in and frameless shower doors. The profile has an 8 mm thickness and 1.6 m length, supplied as a single piece to fit the bottom edge of glass panels. It creates a barrier between the glass and the shower tray or floor, helping to reduce water leakage and maintain a clean, functional enclosure. The clear finish keeps the visual lines of minimalist and contemporary shower designs unobtrusive while providing a practical sealing function.

Advantages

The lower sealing strip is made to provide a secure, low-profile seal at the base of shower glass, minimizing water escape without altering the look of the enclosure. Its transparent material is resistant to typical bathroom moisture and allows light transmission for an unobtrusive appearance. Supplied in a single continuous length, it simplifies replacement and installation on frameless or near-frameless doors, ensuring a consistent fit along the bottom edge of the glass.

Suitable for

• Walk-in shower doors with an 8 mm glass profile
• Frameless and minimal-frame shower enclosures
• Replacement of worn or damaged bottom seals
• Bathroom renovations where discreet sealing is required

Key specifications

• Material: transparent sealing profile suitable for wet environments
• Profile thickness: 8 mm
• Length: 1.6 m (single piece)
• Position: lower/bottom edge of shower glass
• Finish: clear (transparent)

How to use

Measure the bottom edge of the shower glass to confirm compatibility with an 8 mm profile and cut the strip to the required length if necessary. Slide or press the sealing strip onto the lower edge of the glass so it seats evenly along the full length; ensure the seal makes contact with the tray or floor at the intended gap. For a secure fit, clean the glass edge before installation and remove any debris. If trimming is required, use a sharp utility knife or fine-toothed saw and file any rough edges to restore a flush contact surface.

Usage recommendations

Regularly inspect the strip for wear, limescale or deformation and replace it when the sealing effectiveness decreases. Clean with mild detergent and a soft cloth; avoid abrasive cleaners or solvents that could cloud or damage the transparent material. For best performance, ensure the shower glass is within the specified thickness and that the strip is installed straight along the entire lower edge.