Fence panel VidaXL welded wire with 13 spike posts 1 x 25 m galvanized steel

VidaXL welded wire fence panel set provides a 1 x 25 m galvanized steel mesh panel supplied with 13 spike posts for direct ground installation. Designed for marking boundaries and creating low-security enclosures, the welded wire construction and galvanized finish deliver basic corrosion resistance for outdoor use. The set is intended for straightforward post-mounted assembly to protect gardens, yards, small construction zones or temporary perimeters.

Advantages

The galvanized welded wire panel resists rust and is suitable for outdoor exposure without frequent maintenance. Including 13 spike posts allows installers to space supports evenly along the 25 m length for stable mounting. The wire mesh design provides visibility through the fence while preventing casual access, and the spike posts allow installation into soil without the need for extensive foundations. The set is lightweight for handling and transport but constructed to resist normal outdoor loads.

Suitable for

• Marking property boundaries in gardens and yards
• Creating enclosures for lawns, flower beds or vegetable plots
• Temporary or low-security fencing at small construction or renovation sites
• Separating pets or livestock in small paddocks or runs

When it may not be suitable

This welded wire fence panel set is not intended for high-security applications where climb-resistance, anti-cut features or tall barrier heights are required. It may not be appropriate for very exposed coastal locations with severe salt spray unless additional corrosion protection is applied. Hard or rocky ground may prevent proper use of spike posts and require concrete foundations or alternative mounting solutions.

Key specifications

• Panel dimensions: 1 m (height) x 25 m (length)
• Material: galvanized steel mesh
• Included supports: 13 spike posts for ground installation
• Construction: welded wire mesh
• Intended use: outdoor boundary and low-security enclosure

How to use

Position the panel along the desired perimeter and mark post locations at regular intervals corresponding to the included 13 spike posts. Install spike posts into soil using manual or powered driving tools, ensuring each post is vertically aligned and securely seated. Unroll or place the welded wire panel next to the installed posts and attach the mesh to the posts using suitable fasteners or ties at top, middle and bottom points. Check alignment and tension along the full length and trim any excess mesh to finish the run.

What to consider before purchase

• Measure the perimeter to confirm a 25 m length is sufficient or if multiple sets are required
• Assess ground conditions to ensure spike posts can be driven into the soil
• Consider local exposure (coastal salt, chemicals) and whether extra corrosion protection is necessary
• Verify required fence height and security level for your application

Usage recommendations

For stable results, pre-mark post positions and drive posts vertically; secure the mesh with corrosion-resistant ties or clips and periodically inspect fixings and the galvanized surface for damage, especially after severe weather.