Fence posts with driven anchors VidaXL for hexagonal garden mesh 0.8x10 m, galvanized steel, 7 posts Ø32 mm 100 cm

Set of 7 vidaXL fence posts with driven anchors designed for use with hexagonal garden mesh 0.8 x 10 m. Each post is made of galvanized steel with a nominal diameter of 32 mm and a length of 100 cm. The driven-anchor design allows the posts to be installed by driving them into the ground, providing stable vertical support for perimeter fencing, garden enclosures and plant protection while offering corrosion resistance suitable for outdoor use.

Advantages

Galvanized steel construction reduces the risk of rust and extends service life in typical outdoor environments. The driven-anchor base enables quick, tool-minimal installation by being hammered into soil, compacting the surrounding ground for secure holding. Having seven identical posts in one set ensures even spacing and consistent support along a short run of hexagonal garden mesh, simplifying planning and assembly.

Suitable for

• Repairing or installing short runs of hexagonal garden mesh 0.8 x 10 m
• Creating low perimeter fences around vegetable beds, flower borders or small enclosures
• Supporting plant protection netting or temporary animal containment

When it may not be suitable

This set is intended for relatively low-height fencing applications and may not be suitable where taller or load-bearing fencing is required. Very rocky, compacted or frozen ground conditions can make driven-anchor installation difficult and may require pre-drilling or alternative anchoring methods.

Key specifications

• Number of posts: 7
• Material: galvanized steel
• Nominal post diameter: 32 mm
• Post length: 100 cm
• Mounting method: driven anchors (to be driven into the ground)
• Recommended mesh compatibility: hexagonal garden mesh 0.8 x 10 m

How to use

Measure and mark the desired spacing along the fence line to match the length of the hexagonal garden mesh. Position each driven-anchor post vertically, then drive it into the ground using a hammer, post driver or suitable mallet until the anchor is fully embedded and the post is stable. Attach the garden mesh to the posts using wire ties, clips or appropriate fasteners, ensuring the mesh is tensioned evenly to avoid sagging. For hard or rocky soil, consider drilling pilot holes or using a mechanical driver to ease installation.

What to consider before purchase

• Verify compatibility of post spacing with the specific hexagonal mesh dimensions and required tension
• Assess ground conditions (soil type, presence of rocks, frost) to determine if driven anchors are appropriate
• Confirm that 100 cm post length provides sufficient height and embedment depth for your fencing needs

Usage recommendations

For best results, space posts evenly and check vertical alignment during installation. Use suitable fasteners and tension the mesh gradually from one end to the other. In exposed or wet locations, consider additional protective coatings or deeper embedment for increased durability.