Water pump Vorel Flo 79774 — 900 W, 230 V, IPX8, 10 m cable

Vorel Flo 79774 is a submersible water pump with 900 W motor power designed for operation on 230 V / 50 Hz mains. The pump is built for continuous immersion (IPX8) and comes with a 10 m power cable and a compact 4 kg body, offering a balance of performance and portability for water removal and transfer tasks. Its design focuses on dependable continuous water extraction in environments such as basements, wells, flooded areas and garden irrigation systems.

Advantages

The pump’s 900 W motor delivers sufficient flow for typical drainage and irrigation needs while remaining compact and easy to position. IPX8-rated construction permits prolonged submersion without compromising electrical safety. A 10 m cable increases placement flexibility and reduces the need for extension cords. The relatively low weight and compact dimensions simplify handling, lowering setup time when moving between locations.

Suitable for

• Draining basements and cellars after flooding
• Emptying wells, sumps and cisterns
• Garden irrigation and water transfer between containers
• Temporary removal of standing water from construction sites or garages

Key specifications

• Power: 900 W
• Supply voltage and frequency: 230 V / 50 Hz
• Ingress protection: IPX8 (continuous immersion)
• Cable length: 10 m
• Weight: approximately 4 kg
• Type: submersible water pump

How to use

Place the Vorel Flo 79774 pump fully submerged in the water at the lowest practical point while ensuring the pump sits on a stable, level surface. Connect the power plug to a properly grounded 230 V outlet that is protected by a residual current device where applicable. Route the discharge hose or pipe to a safe drainage point and switch the pump on according to the supplied instructions. Monitor operation during initial use to confirm stable water flow and secure hose connections. After use, disconnect power before lifting the pump from the water and allow it to drain and dry before storage.

Usage recommendations

To prolong service life and maintain safe operation, avoid running the pump dry, remove large debris from the water before submersion, and check the power cable for damage prior to each use. Use appropriate hoses and fittings rated for the expected flow and pressure, and ensure electrical connections comply with local safety regulations.