Needle applicator, Wamod Modeler WM-04, 30 ml capacity needle

Wamod Modeler WM-04 is a needle applicator designed for controlled dispensing of fluids and pastes. With a 30 ml capacity reservoir and a fine needle tip, this tool enables precise placement of adhesives, sealants, lubricants, inks and modelling materials. Its construction supports steady metering for small-scale repair, craft, hobby and prototyping tasks where accuracy and minimal waste are important.

Advantages

The narrow needle tip provides pinpoint accuracy and reduces overspill, while the 30 ml reservoir offers a balance between frequent refills and compact handling. The applicator is compatible with low- to medium-viscosity materials used in hobby modelling, electronics repair and light industrial prototyping. Its ergonomic body allows controlled pressure during dispensing and improves repeatability of application volumes.

Suitable for

• Applying adhesives and cyanoacrylates in small repairs
• Dispensing sealants in precision joints and seams
• Lubricant point application on mechanisms and gears
• Placing inks, paints or modelling putties in scale modelling
• Controlled dispensing of fluids during prototype assembly

Key specifications

• Reservoir capacity: 30 ml
• Needle-style narrow tip for precise dispensing
• Suitable for low- to medium-viscosity fluids and pastes
• Compact, handheld design for one-person operation
• Ergonomic body for pressure control and repeatable dosing

How to use

Fill the reservoir with the chosen fluid or paste, ensuring compatibility with the needle aperture and body materials. Secure the needle tip and remove any air pockets by gently depressing until a small amount is dispensed. Hold the applicator near the work surface, apply steady pressure to the body to release the required amount, and move the tip smoothly to achieve an even line or droplet. After use, clean the needle and reservoir according to the material handled to prevent clogging and maintain consistent performance.

Usage recommendations

Use the applicator with materials within the recommended viscosity range; very high-viscosity substances may require pre-heating or alternative dispensing equipment. Store with the needle cap in place to avoid drying or contamination. For adhesives prone to curing in air, purge the needle and clean immediately after use.