Firewall module WatchGuard Firebox T80 1 Port 10Gb SFP+ Module WG9010

The WatchGuard Firebox T80 1 Port 10Gb SFP+ Module provides a single 10 gigabit SFP+ fiber interface designed to expand connectivity options for compatible Firebox T80 appliances. This compact network module adds a high-speed uplink or aggregation port, enabling integration with data center links, WAN circuits, or core network infrastructure without replacing the main appliance. It is intended as an interface extension to support higher-throughput environments where fiber connectivity and low-latency links are required.

Advantages

This 10Gb SFP+ module delivers increased bandwidth and low-latency performance through a standard SFP+ port, allowing the appliance to connect directly to 10 gigabit fiber networks. Installation is straightforward and preserves the existing Firebox T80 chassis and configuration while providing a higher-speed physical interface. The module supports common SFP+ transceivers and cabling used in enterprise edge and aggregation scenarios, enabling flexible deployment without complex reconfiguration.

Suitable for

• Connecting a Firebox T80 to data center uplinks and aggregation switches
• Integrating the appliance into WAN or internet service provider circuits that require 10Gb fiber
• Core network connections where a high-speed, low-latency link is necessary
• Network designs that separate firewall throughput from existing copper interfaces

Key specifications

• Interface: 1 × 10 Gigabit SFP+ port
• Form factor: Hot-swappable network module compatible with Firebox T80 chassis
• Supported media: SFP+ optical transceivers and appropriate fiber cabling
• Use case: Uplink, aggregation, or core link for high-throughput environments
• Performance: Designed to support 10 Gbps line rate connectivity

How to use

Power off the Firebox T80 or follow the manufacturer’s hot-swap instructions if supported, then insert the module into the appropriate expansion slot of the appliance. Install a compatible SFP+ transceiver and connect the fiber cable to the module. After physical installation, verify the module is recognized by the appliance management interface and configure the network settings for the new 10Gb port, including VLAN, routing, and firewall policies as needed. Perform link and throughput tests to confirm proper operation.

Usage recommendations

Use multimode or single-mode SFP+ transceivers and fiber that match your existing infrastructure and distance requirements. Ensure the Firebox firmware is up to date and consult the appliance documentation for supported transceiver types to maintain compatibility and optimal performance.