WENTRONIC Goobay CAT 6A S/FTP Patch Cable (PiMF), white, model 79320

WENTRONIC Goobay CAT 6A S/FTP Patch Cable (PiMF), white, model 79320 is a shielded network patch cable engineered for high‑speed 10 Gigabit Ethernet connections in office and data center environments. The S/FTP (shielded/foiled twisted pair with overall braid) construction provides individual foil shielding for each twisted pair plus an overall braided shield to reduce near‑end crosstalk (NEXT) and electromagnetic interference (EMI). The white jacket and flexible design make it suitable for visible installations and dense cable routing in patch panels, switches and workstations.

Advantages

The S/FTP (PiMF) construction ensures improved signal integrity and lower interference compared with unshielded cables, supporting reliable data transmission at 10 Gbps over suitable channel lengths. The cable is built to meet CAT 6A performance requirements for bandwidth and crosstalk, while its flexible jacket simplifies routing in confined spaces and reduces installation effort. The white outer sheath provides a neutral appearance for office or data center installations.

Suitable for

• Patching 10 Gigabit Ethernet switches to patch panels in data centers and server rooms
• Connections between wall outlets and workstations where EMI reduction is required
• High‑density rack installations where flexible routing and reliable shielding are needed
• Network segments that require CAT 6A performance for bandwidth and crosstalk control

When it may not be suitable

This shielded CAT 6A patch cable is primarily intended for environments where EMI or crosstalk can affect signal quality; in low‑interference home networks or short runs that do not require 10 Gbps throughput, an unshielded CAT 5e or CAT 6 cable may be sufficient and more cost‑effective. Additionally, if your installation lacks proper grounding for shielded cabling, you should verify grounding practices to ensure the benefits of the shielding are realized.

Key specifications

• Cable category: CAT 6A
• Shielding: S/FTP (individual pair foil — PiMF — plus overall braid)
• Performance: designed to support 10 Gigabit Ethernet
• Conductor type: twisted pairs (solid or stranded variant as per model family)
• Color: white outer jacket
• Connector type: RJ45 compatible on both ends

How to use

Plug one end of the patch cable into the RJ45 port of your switch, patch panel or network outlet and the other end into the corresponding device or workstation. Route the cable along cable management trays, horizontal managers or within patch panels to avoid sharp bends and excessive strain. Ensure connectors are fully inserted and latched to establish reliable electrical contact. For optimal shielding effectiveness, verify that connected shielded equipment and patch panels are properly grounded.

What to consider before purchase

• Required maximum data rate and whether 10 Gigabit Ethernet support is necessary
• Length needed for the intended run and allowance for routing paths to avoid tension
• Whether your installation provides proper grounding for shielded cables
• Color preference for visible cable runs and compliance with site cabling standards

Usage recommendations

For best performance, use this CAT 6A S/FTP patch cable for channel runs within recommended length limits, maintain gentle bend radii, and pair with shielded patch panels and grounded equipment to maximize EMI protection and data integrity.