Industrial cam switch Elektromet Łuk E16-63 3P 16A 0-1-2-3 in IP44 enclosure

Cam switch Elektromet Łuk E16-63 3P 16A 0-1-2-3 in IP44 enclosure is a compact, panel-mounted manual selector switch designed for basic industrial and workshop switching tasks. The device provides three poles and four positions (0, 1, 2, 3) that enable reliable circuit selection and straightforward control of motors or multi-source circuits. Housed in an IP44-rated enclosure, the switch offers protection against solid objects greater than 1 mm and water splashes, making it suitable for environments where occasional moisture or dust may be present.

Advantages

The switch combines a simple mechanical design with durable contacts to deliver consistent electrical switching at rated current. Its three-pole configuration supports three-phase or multi-line applications, while the clearly marked positions allow unambiguous operator control. The included IP44 enclosure simplifies mounting and provides basic environmental protection without the need for separate housing, helping to reduce installation time and panel complexity.

Suitable for

• Manual selection of three-phase motor circuits
• Switching between different power sources or circuit paths
• Control panels and machine enclosures in workshops and light industrial settings
• Applications requiring a compact, panel-mounted selector with splash protection

Key specifications

• Poles: 3 (three-pole switching)
• Positions: 0 — 1 — 2 — 3 (four-position selector)
• Rated current: 16 A
• Mounting: panel-mounted / front-panel installation
• Enclosure protection: IP44 (protection against solids >1 mm and splashing water)
• Actuation: manual cam-operated selector

How to use

Install the cam switch into a prepared panel cutout and secure it according to the panel-mounting instructions, ensuring proper alignment and torque of the retaining hardware. Connect supply and load conductors to the terminal points following the wiring diagram and local electrical regulations; ensure power is disconnected before wiring. Use the selector positions to change circuit routing or motor connections: position 0 for off or neutral, and positions 1–3 for the required operating circuits. Verify proper operation after installation by testing each position under no-load and then under normal load conditions.

Usage recommendations

Use conductors and terminal ferrules sized for the rated current and maintain secure torque on terminals to prevent heating. Keep the enclosure seals and gasket areas free of debris to preserve IP44 protection. Perform periodic inspections for contact wear and proper mechanical operation, and replace the switch if excessive wear or unreliable switching is observed.