Liquid adhesive Pattex PCL6C 650 g

Pattex PCL6C 650 g is a liquid polychloroprene adhesive designed for general bonding tasks where fast drying and flexible joint performance are required. Supplied in a 650 g tube dispenser, the adhesive is formulated to deliver strong initial tack and durable adhesion on a range of substrates when used at recommended temperatures. The product is intended for use in environments where a short open time and reliable bond strength are important.

Advantages

This liquid adhesive offers a rapid drying time of approximately 15 minutes under recommended conditions, enabling quicker handling of bonded assemblies. The polychloroprene formulation provides a balance of high initial tack and long-term flexibility, helping joints resist impact and vibration. The tube dispenser simplifies application, reduces waste and allows controlled dosing. The adhesive is suitable for use across multiple materials, maintaining bond integrity once fully cured.

Подходит для

• Склеивания резины с металлом и тканью
• Монтажных и ремонтных работ, требующих быстрого сцепления
• Соединения гибких и жёстких материалов, где нужна эластичность шва
• Работы в мастерских и бытовых условиях при рекомендованной температуре

Key specifications

• Formulation: liquid polychloroprene adhesive
• Net content: 650 g in a tube dispenser
• Typical drying time: around 15 minutes at recommended conditions
• Recommended application temperature: 18 °C to 25 °C
• Application properties: high initial tack, flexible cured bond

How to use

Prepare bonding surfaces by ensuring they are clean, dry and free from dust, grease or loose particles. Apply an even coat of Pattex PCL6C from the tube dispenser to one or both surfaces according to the required bonding method. Allow the adhesive to flash off until it reaches the specified open time (approximately 15 minutes under recommended temperature), then join the parts and apply uniform pressure to ensure contact across the bonded area. Allow sufficient curing time before placing the assembly under load.

Usage recommendations

Work within the recommended temperature range of 18 °C to 25 °C for optimal drying and bonding performance. For porous or highly absorbent substrates, perform a preliminary test and consider applying adhesive to both surfaces. Use protective gloves and ensure adequate ventilation during application. Store the tube in a cool, dry place and follow local disposal regulations for adhesive residues and empty packaging.