Adhesive liquid Pattex model 9H PP3KH — tube dispenser, 14 g, for repairs and bonding

Pattex adhesive liquid model 9H PP3KH is a single-component adhesive supplied in a compact 14 g tube dispenser. The product contains a liquid formulation intended for small repairs and bonding tasks around the home or for hobby projects. The tube dispenser enables controlled application of a thin bead, making it suitable for joining parts where precise dosing and a small quantity are needed.

Advantages

This Pattex adhesive provides a fluid consistency that penetrates small gaps and bonds a range of common materials used in household repairs. Its single-component format requires no mixing or special tools and the tube dispenser offers easy, targeted application with minimal waste. The small 14 g capacity makes it convenient to store and carry for occasional fixes.

Suitable for

• Small repairs of plastic parts, ceramics and some coated surfaces
• Hobby and craft bonding where fine application is needed
• Minor household fixes such as loose trims, model assembly and quick touch-ups

When it may not be suitable

The liquid adhesive is designed for small-scale repairs and may not be appropriate for heavy structural bonding, load-bearing joints or large surface laminations. It may perform inconsistently on certain materials such as untreated silicone, polyethylene, polypropylene or other low-energy plastics unless surfaces are pretreated or a specialist adhesive is used.

Key specifications

• Form: single-component liquid adhesive
• Dispenser type: squeezable tube for fine application
• Net content: 14 g
• Intended users: adults for household and hobby use

How to use

Ensure surfaces are clean, dry and free from dust, grease or loose particles. Trim the tube tip for an appropriate bead size and apply a thin layer of adhesive to one surface. Join parts immediately and hold them in position until initial set. For best results, follow any safety and curing information supplied with the product and allow adequate time for full strength to develop before subjecting the bond to stress.

What to consider before purchase

• Confirm compatibility with the materials you intend to bond, especially plastics with low surface energy.
• Assess whether a 14 g tube provides sufficient quantity for your planned tasks.
• Check required handling and curing conditions for your application (temperature, clamp time, ventilation).

Usage recommendations

Use the tube dispenser for precise, small-diameter beads and store the product with the cap secured to prevent drying. For best adhesion on difficult plastics, consider surface preparation such as light abrasion or a suitable primer. Keep out of reach of children and follow safety instructions on the packaging.